Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Washer wouldn’t power on after button was pressed
Removed main PCB assembly carefully from assembly. Then removing cables at the connectors . Plug cables into new PCB and reinstall. Take note how and where the cables go when removing from old. I would suggest to take a picture on you smart phone for insurance. Do not force connectors off they will release be gentle.
washer making noise when washing. rinse and spin was normal.
Everthing went to plan except the wet side of the parts removal was difficult. used puller to remove the wash plate and got it to release. But the plastic part of the wash plate released and left the aluminum part still on the coupling. Corrision was the problem, and I had to again use a puller to remove this part of the wash plate. So it wasn't a matter of just lifting the wash plate off by hand. The rest of the replacement was fine.
Detergent and Softner dispenser was not working peoperly
The old dispenser is removed by slightly raising the front as you pull it out of the housing slot. To install the new dispenser, keep the front slightly tilted up and insert the new dispenser into the housing alot
Washer pulsator was coming loose during wash cycle.
Since the old pulsator had actually come off during a wash cycle, I was able to place the new one on easily. Tightened the screw with a socket. Then placed the new cap on. Before placing the new pulsator on, I was able to clean all the mold and hard deposits off the mechanism under the pulsator. The hard deposits were also scrapped from the pulsator holding (where the screw goes) which may have caused the problem to begin with.
Three of the four pivot hangers broke while the washer was spinning.
Once i got the parts I removed the top so I could get to the hangers. I removed the broken parts and replaced them with the replacement parts and rehung the tub and replaced the top.