RGH647GEJ1 Hotpoint Range - Instructions

Unscrew the metal rim and remove the glass window. Remove the old bulb by twesting the bulb towards you. Place the new bulb's pins into the slots and twest away from you. Place the metal rims back in place and screw them down.

Pulled the knob's off the front of the stove. Removed 7 phillps screws holding on the front plate, pulled off the front plate, removed the ignitenr, and then reassembed the stove. It worked great.

Removed old ignighter and replaced it with the new one. No brainier. Took longer to find the correct part, mine had three wires, most are just two.

Just put the new knobs on and they worked good as new.

I just had to lift the top of the stove. Then pull the old burners out and put the new ones. It took longer to ignite the flame than replace the burner. Works great !!!

I really didn't have a clue as to where to get one so I just went without a knob not using the burner for about a year. Then I decided to call a handyman. He said the part would cost $20 and labor would be $50. I said forget it. I immediately got on my iPad and researched. I found the exact part! It came in less than 30 hours of ordering it. Then I opened the plastic bag with the knob in it, and it fit exactly right into place. And Voila! I could finally use that burner again. It was so easy to Install, no,tools necessary. It fit right into place ! I should have done that earlier had I known it would be so easy!

it was tooooo easy. Just pushed the new one on.