Models > MV1840ASDL > Instructions

MV1840ASDL LG Microwave - Instructions

All Instructions for the MV1840ASDL
16 - 23 of 23
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
light bulb replacement
very simple
Parts Used:
Light Bulb - 120V 30W
  • Marianne from CHURCH HILL, MD
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
8 of 27 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken grill assembly
Grill would not go into place without removing the control panel. Had to remove one screw at top of panel and then install grill and control panel at the same time. Once all are in place you are unable to replace the screw holding the control panel. The grill seems to hold he panel in place securely. Should have been easier but the grill tabs just would not go into place with control panel attached.
Parts Used:
GRILLE ASSEMBLY
  • Mark from Redding, CA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
plastic bosses on front panel broke so screws would not hold
Used screw gun with long bit to disassemble door and then to reassemble.
Parts Used:
Complete Door Assembly - Stainless Steel
  • Richard from Bloomington, MN
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Glass tray broken
really easy
Parts Used:
TRAY,GLASS
  • Ernest from Jacksonville, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Light bulb burned out
I unscrewed the light cover, removed the burned out light bulb and replaced it with one I ordered on Partselect.com. It was very easy.
Parts Used:
Light Bulb - 120V 30W
  • Craig from Burke, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
no heat
unplug the unit then pull down , lot of screws are on top. open the cover . you could see the parts that need to replace on the right hand side (heavy side). disconnect wires then test the parts that need to replace by a tester to make sure that it's really broke .then unscrew part and replace .
Parts Used:
Magnetron
  • Nelia from Streamwood, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Microwave would not heat food, but everything else worked.
Problem was a faulty door latch switch. I easily accessed the switch by removing the control panel, total of 4 screws. After that, just disconnected the three switch door latch assembly and connected the new one. Took about half an hour and was very easy. Unit works perfectly now.
Parts Used:
Holder Assembly,Locker
  • Samuel from Daleville, VA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The front glass of the microwave broke, the upper grill broke
To install the door, you need to pull the top grill(molding), remove the inner molding frame from the door. Hold the dor and pull it up to unlock and slide out. To instal new door, simply remove the inside plastic molding and place the for in. Replace the milding to lock it. Instal the upper grill ( molding). The control pannel might give an error at first. Dimply adjust the foor by closing and open several times.
Parts Used:
GRILLE ASSEMBLY Complete Door Assembly - Stainless Steel
  • Gustavo from Waukegan, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the MV1840ASDL
16 - 23 of 23
Back to Top