Models > CRG3480PBD > Instructions

CRG3480PBD Frigidaire Range - Instructions

All Instructions for the CRG3480PBD
76 - 78 of 78
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
oven took too long to heat up
un bolted the 6 nut driver heads found probe wire un pluged it 1/4 turn from lock it was in and pull out replace slide in new probe 1/4 turn to lock it in place replace nut driver self tappers and test simple!!
Parts Used:
Temperature Sensor
  • JAONNE from GAFILED, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Controller went out after storm.
Repair was easy, quick and worked perfect. Removed old controller and installed new one. Part came quick. Will use part select again!!
Parts Used:
Electronic Control Board
  • Jill from Murray, KY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
replace lower oven floor
removded 2 screws at rear of panel, moved panel toward rear of oven, lifted up and out. Slid in new panel in front groove then lowered onto oven floor and secured it with the 2 screws at rear of oven.
Parts Used:
Panel
  • ed from petaluma, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CRG3480PBD
76 - 78 of 78
Back to Top