KitchenAid Dishwasher Wheels and Rollers

KitchenAid Appliance Parts
Shop By Part Type

Popular KitchenAid Dishwasher Wheels and Rollers

Your Price
$38.64
  On Order
Dishwasher Lower Dishrack Wheel Assembly - Gray
★★★★★
★★★★★
(249)
PartSelect Number PS11722152
Manufacturer Part Number W10195416V
This OEM gray Dishwasher Lower Dishrack Wheel Assembly is a plastic kit that allows the rack to slide in and out of the dishwasher easily. If it breaks or becomes damaged. sliding will feel difficult. This can happen due to normal wear and tear, and the part should be replaced if this occurs. Check your model number and user manual to make sure this part is correct. It attaches directly to the dishrack. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. It measures roughly 3x6 inches.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...
Installation Instructions
Thomas from WEST OLIVE, MI
Broken wheel unit on the bottom dish rack
All you do is pop out the old wheel unit at two (2) points on the plastic wheel housing and pop in the new one. Easy fix. Less than a 5 minute fix. Read more...
Your Price
$55.94
  On Order
Dishwasher Lower Dish Rack Roller
★★★★★
★★★★★
(67)
PartSelect Number PS11750057
Manufacturer Part Number WPW10195417
The Dishwasher Lower Dishrack Roller is a grey plastic part which attaches to the bottom of the lower dishrack, allowing you to slide it easily in and out. If the rack no longer moves smoothly or shows visible damage then it may be time to replace it. Check your model number and user manual to see if this is the right part for your appliance. To attach this part to your dishwasher, align the adjustable tines with the middle slot in the roller assembly. From there, it should just snap into place on the rack. The wheels and pins for this part are only sold as an assembly of two per set in this part, unfortunately, these individual components are not available to purchase separately.
Installation Instructions
Dan from HUNTERTOWN, IN
one wheel came off a lower rack 2 wheel roller piece
push the 2 retaining clips back with my fingers and slide off the broken roller piece. Slide the new replacement 2 roller piece into place and push up until the retainer clips click and lock. Read more...
Your Price
$27.77
  In Stock
Upper Rack Wheel with Mount
★★★★★
★★★★★
(47)
PartSelect Number PS11745451
Manufacturer Part Number WP8268655
This is a replacement upper dish rack wheel with mount for your dishwasher. The mount supports the dish rack, and the wheel allows the rack to slide out easily. To replace this part, remove the rack stops and pull out the upper dish rack. This wheel mount pops off, and the new one can be snapped into place.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...
Installation Instructions
James from Gulfport, MS
The wheels on the upper dish rack broke
I removed the end caps on the slides with needle nose pliers, removed the old wheels and installed the new ones, then I snapped the slide end caps back on. Super responsive service from PartSelect.com Thanks! Read more...
Your Price
$10.76
  In Stock
Upper Rack Wheel and Mount Assembly
★★★★★
★★★★★
(12)
PartSelect Number PS11745525
Manufacturer Part Number WP8270019
Sold Individually.
Fixes these symptoms
Installation Instructions
Kevin from Hurst, TX
top dw rack fell off of rollers
Amazingly, this not-too-old dishwasher's plastic parts that hold the top rack onto the sliders became brittle (a real design flaw, in my opinion) and the tabs that held the rollers in place all broke off. With the right parts and the great instructions on this site, the repair was fairly easy and we saved a lot of $$ by not having to call for service. Just follow the instructions... Read more...
Your Price
$34.07
  In Stock
Dishwasher Upper Rack Roller
★★★★★
★★★★★
(23)
PartSelect Number PS11753471
Manufacturer Part Number WPW10350401
This assembly is the wheel and the mount for your upper dishrack. Sold individually. This is an authentic OEM part for use with Whirlpool, KitchenAid, Kenmore and Jenn-Air Dishwashers. The dishrack wheel lets you roll the rack easily on the support rails. This part is sold individually. The most common reason for replacing the dishrack wheel is if it breaks causing the rack to jam. The tool that you will need to replace the dishrack wheel is a flathead screwdriver.
Fixes these symptoms
Installation Instructions
Jesse from CHARLOTTE, NC
Replace Upper Wheel Hub
1) Remove (2) dishwasher cabinetry (located on top or side) cap and screws.
2) Pull dishwasher out just far enough to access wheel tub assembly.
3) Remove old, clean area and replace with new.
“Refer to several videos buy goggling part number”.
Read more...
Your Price
$35.17
  In Stock
Dishwasher Upper Dish rack Wheel Mount
★★★★★
★★★★★
(52)
PartSelect Number PS11745459
Manufacturer Part Number WP8268743
This upper dish rack wheel mount can be used on either side of your dish rack. It is sold individually. The part includes the wheel and support, which attaches to the dish rack and allows it to slide in and out easily.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...
Installation Instructions
Jason from Todd, NC
Worn dishrack wheel mount
This wheel mount broke from normal use and made the upper dish rack disconnect from the sliding arm that extends it outside the dishwasher body so that you can fill it. The part was delivered quickly and was easy to install using just a screwdriver to loosen the retainer clip on the end of the extension slide. Once the retainer clip was removed, the new part was slid into place and clipped onto the rack. The install was complete. Read more...
Your Price
$7.09
  In Stock
Dishwasher Dishrack Roller
★★★★★
★★★★★
(6)
PartSelect Number PS11755768
Manufacturer Part Number WPW10505748
This is a tub wheel assembly for your dishwasher. This assembly, complete with two rollers on a supporting bracket, supports the rack along the upper rail or track to allow the rack to slide smoothly. You may need to replace this if the rollers are broken or jammed. The part is gray in color and is made of plastic. You will need to remove your upper rack to install this replacement tub wheel assembly.
Installation Instructions
Richard from TRUCKEE, CA
Fully loaded top rack would detach from track when pulled out for emptying.
Removed dishwasher from cabinetry to replace tub rollers (4). Replaced roller sets (4) on top rack. Also replace both rails and rail stops. Screwdriver was only tool required for this part of repair. Needed wrench and screwdriver to remove and replace dishwasher in lower cabinetry. Read more...
Your Price
$28.25
  In Stock
Stationary Wheel and Mount
★★★★★
★★★★★
(14)
PartSelect Number PS11745464
Manufacturer Part Number WP8268785
Sold individually.
Fixes these symptoms
Installation Instructions
Polly from Powell, OH
Wheel on top rack broke
In less than 5 minutes, we removed the stopper on the end of the arm that held the top rack, slid off the top rack, rotated off the broken wheel assembly, rotated on the new one, slid the rack back on, and replaced the stoppers. Read more...
Your Price
$41.98
  In Stock
Lower Dishrack Wheel
★★★★★
★★★★★
(10)
PartSelect Number PS11751413
Manufacturer Part Number WPW10261335
Sold individually.
Installation Instructions
mary from LA GRANGE PK, IL
dish rack wheels plastic broken
just replaced broken piece ,,,, very easy ,,, will use you again for parts should the need arise Read more...
Your Price
$32.89
  In Stock
Upper Rack Wheel
★★★★★
★★★★★
(11)
PartSelect Number PS11748156
Manufacturer Part Number WPW10078214
Sold individually.
Installation Instructions
Rhonda from STATESVILLE, NC
Broken wheel upper rack
Pulled tip off wheel rack in slid broken wheel out slid new wheel in replaced plastic gray end of rack Read more...

Related Parts