KitchenAid Dishwasher Spray Arms

KitchenAid Appliance Parts
Shop By Part Type

Popular KitchenAid Dishwasher Spray Arms

Your Price
$10.20
  In Stock
Upper Spray Arm Mount
★★★★★
★★★★★
(54)
PartSelect Number PS11746245
Manufacturer Part Number WP8539324
This upper spray arm mount has been redesigned by the manufacturer, so it not longer requires a clip and screw to be installed. To replace this part, first remove the rack stops from the upper dish rack and pull out the dish rack to work on it. Remove the screw holding the spray arm in place, take off the spray arm and slide out the feeding tube. Flip the rack over to remove the mounting bracket from the mount. Snap the new mount into place and replace the other parts.
Fixes these symptoms
Installation Instructions
Sibyl from Sparta, NJ
The top spray arm of my dishwasher broke off in my hand.
I removed the screw holding the spray arm to the bracket. I then put on the new bracket and tightened the screw. The bracket just clips on to the top basket of the washer. Easy as pie. Read more...
Your Price
$38.80
  In Stock
Middle Spray Arm Kit
★★★★★
★★★★★
(92)
PartSelect Number PS382824
Manufacturer Part Number 675808
This middle spray arm kit includes an upper spray arm, a holder or hanger, water supply tube or delivery tube, split ring seal, and a screw. The function of these parts is to spray water to all levels of the dishwasher so the dishes will come out completely clean. This kit has recently been redesigned. It does not include the upper support or mount, so consider ordering those parts as well if necessary. The spray arm is approximately 18 inches long, and all parts are white in colour. The only tool you will need to complete this repair is a Phillips screw driver.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...
Installation Instructions
Robert from York, PA
Lower spray arm was not turing properly and causing poor wash results
I noticed the upper bushing washer was worn thin. this caused the lower spray arm to rise too high and wobble during all the wash cycles. Also the rotation of the lower spray arm was wearing grooves in the lower bushing.

I removed the retaining nut and simply replaced teh defective parts. While I was at it I figured equal wear might be evident on the upper spray arm so I bought a complete rebuild kit to bring all rotational parts back to new and equal preformance that was achieved by removing the ss screw and removing the upper spray arm, bushing and clip then replacing them in the order of removal. Noticed a huge difference in the quality of the washed dishes!! Thanks Parts Select 100% to yoru company!!
Read more...
Your Price
$20.55
  In Stock
Wash Arm Bearing Ring
★★★★★
★★★★★
(24)
PartSelect Number PS11747064
Manufacturer Part Number WP9742946
This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...
Installation Instructions
James from Jacksonville, FL
Dishes not clean and lower wash arm wobbled.
Completely removed lower wash arm and replaced bearing ring and seal. Read more...
Your Price
$11.35
  In Stock
Seal, Lower Sprayarm
★★★★★
★★★★★
(11)
PartSelect Number PS11741334
Manufacturer Part Number WP3376846
This dishwasher lower spray arm seal, or under spray arm bearing ring, is designed with the split by the manufacturer. It is not damaged or defective, and is sourced directly from the original manufacturer. This part is approximately 2 inches in diameter, made of plastic, and is white in color. This part is mounted underneath the dishwasher spray arm and creates a seal between the lower spray arm and the sump housing. To access the seal, remove lower dish rack and unscrew the nut that secures lower spray arm to the remove cover. No tools are required to replace the lower seal on your dishwasher.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...
Installation Instructions
James from Jacksonville, FL
Dishes not clean and lower wash arm wobbled.
Completely removed lower wash arm and replaced bearing ring and seal. Read more...
Your Price
$31.54
  In Stock
Spinner Kit
★★★★★
★★★★★
(22)
PartSelect Number PS972316
Manufacturer Part Number 8193983
This is also called the 3rd-level spinner. This part works like a little spray arm at the top of your dishwasher.
Fixes these symptoms
Installation Instructions
paul from erie, CO
spinner kept falling off
i removed the top screw for the water input to the spinner, which gave me enough room to replace the worn nipple pin that the spinner snaps on to. then snapped the new spinner in place. and then screwed everything back into place. Read more...
Your Price
$34.33
  On Order
Upper Wash Arm Kit
★★★★★
★★★★★
(38)
PartSelect Number PS392681
Manufacturer Part Number 8193504
This part contains the mounting clips and helps distribute water from the top of the dishwasher tub.
Fixes these symptoms
Installation Instructions
Donald from Sunnyvale, CA
The old upper wash arm fell off.
I dropped the upper rack to its lowest position.
I pulled the upper water channel down from the spring clip [on the top of the washer] to get access to the hole on the top of the front end of the channel. The front end of the channel only drops an inch or two.
I put the new upper wash arm pivot [larger of the two small pieces] through the new upper washer arm from the bottom, placed the assembly up into the hole on the under side of the upper water channel, and snapped in the new keeper [smaller piece] through the hole in the top of the upper washer arm.
Finally, I snapped the upper water channel back into its spring clip. It was not even necessary to remove the racks.
There were no instructions or diagrams with the new parts, so it took me a few minutes to be sure which of the two small parts goes in from the bottom and which goes in from the top. Otherwise, I could have installed the new washer arm in one or two minutes.
Read more...
Your Price
$23.97
  In Stock
3rd Level Wash Spinner Kit
★★★★★
★★★★★
(17)
PartSelect Number PS734590
Manufacturer Part Number 8193768
This part is the top spinner located at the very top of the wash tub. Water passes through all the spinners causing it to dispense all around the tub.
Fixes these symptoms
Installation Instructions
Peter from princeton junction, NJ
Old spinner fell after washing the dishes.
Carefully unscrewed the top screw holding the spray arm so it doesn't fall into the tub.

Pull down the arm gently and pop out any remaining parts from the old spinner.

While the spray arm is pulled down, snap the two parts of the spinner together: one from above the spray arm, and one from below the spray arm. (you need to snap them together before you screw the spray arm back, because it won't snap together otherwise.)

Rescrew the spray arm and you are done.
Read more...
Your Price
$7.76
  In Stock
Spray Arm Seal
★★★★★
★★★★★
(3)
PartSelect Number PS11745436
Manufacturer Part Number WP8268340
Also known as a wash arm seal.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...
Installation Instructions
Fred from Grafton, OH
Lower spray arm seal replacement
Remove upper tray and spray arm. Remove two screws retaining pipe for upper spray arm and overhead. Unscrew retainer on top of lower spray arm and remove. Gently rotate the upper feed pipe clockwise until pipe can be removed from lower pipe. You may then remove the lower pipe and bearing housing where the seal is. Reverse order for reassembly. I also replaced upper spray arm bushing. Very simple, remove one screw and the arm will come out. Read more...
Your Price
$35.53
  In Stock
Spray Arm
★★★★★
★★★★★
(5)
PartSelect Number PS11754873
Manufacturer Part Number WPW10448645
This is an upper spray arm for a dishwasher. While the appliance is in use, the spray arm rotates while water travels through it to distribute water evenly throughout the dishwasher tub. This ensures the dishes are efficiently and properly cleaned. It measures approximately 19 inches long and is grey in color.
Fixes these symptoms
Your Price
$34.79
  In Stock
Upper Spray Arm
★★★★★
★★★★★
(3)
PartSelect Number PS11752935
Manufacturer Part Number WPW10327455
The upper spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If your dishes are not being cleaned properly, you should check if there is an issue with the spray arm. To check your spray arm, make sure the spray arms can move evenly and freely on their bearing rings and mounting brackets. Remove your spray arm and check to ensure they are straight and undamaged. This spray arm is made of high-quality plastic and is just over 5 inches long.
Fixes these symptoms

Related Parts