Manifold WPW10340542

Do you have just the gasket for the part 10340542. It is located t the back of the washing machine, on the upper arm.

Hi, i am about to order replacement "rack adjuster kit" (ps10064063) as our wheels have broken off (which appears to be a common problem with these units). My question: As we have taken the top rack out we notice that at the connection end of the under-mount "manifold" for the "sprayer" there are two water intakes that have these 7/8" round screens (filters?) that appear to be hinged flap type things. One screen springs back while the other side remains half open. We assume the sprayer is operating ok but wonder if the filter things are critical and if its a necessary (or wise) to to replace the manifold and sprayer (parts ps11753224 and ps11754873) while we replace the rack adjusters? We love our dishwasher and want to keep it good condition. Thanks!

I found the end piece of the manifold at the bottom of the dishwasher. It is white and two holes and goes into the vertical section at the back of the manifold. It is stamped PP-20/TEO. I can click it back into place but is there a separate replacement part for this? Or would I need to order the whole manifold assembly? Is it critical for the operation of the machine?

Hello, so recently found 2 parts at the bottom of my dishwasher. It appears they broke off the back end of the manifold. They are rectangular, one is white hard plastic and is stamped with W10194944 4. The other is black flexible rubber and stamped with W10707572. They both have two holes. Are these parts available on their own or does the entire manifold have to be replaced?

The gasket on the spray arm has two covers with the black rubber acting as flaps. If one of the flaps stays open, would that prevent the rotation of the top and bottom spray arms? Everything is working correctly other than the sprayers not spinning and actually getting the dishes clean.

Upper rack slides out since day one. I watched the tech level the hell out of the dishwasher and when i noticed this happening i checked too. It's level!!! when the upper rack is in the bottom most position it is not a problem. when you pull the rack out it has a positive retaining feel to it. when it is in the upper most position (which we need for the size of our dishes) it slides out. i put my finger to the opening of the manifold and the door swings back and probably gives the rack enough resistance to stay put. when it is in the upper position the door is wide open with no resistance at all. does it seem reasonable that replacing the manifold will fix this?

I am looking for the plastic end valve for the 2nd rack manifold for my dishwasher. it fits onto the end of the manifold and has a black rubber valve with 2 flaps to let water out. can inorder this piece or do I have to order the manifold which will have this piece? thanks