KitchenAid Dishwasher Dispensers

Your Price

$118.49

Detergent Dispenser

★★★★★

(12)

PartSelect Number PS11731570

Manufacturer Part Number W10861000

Detergent dispenser W10861000 is an original equipment manufacturer (OEM) part that fits some Whirlpool, KitchenAid, Maytag and Amana dishwashers. Detergent dispenser W10861000 attaches to the inner door panel and holds the dishwasher detergent and rinse aid in covered compartments. This dishwasher detergent dispenser measures approximately 5 inches wide and 4.5 inches high.

Fixes these symptoms

Door latch failure
Not cleaning dishes properly
Will not dispense detergent
See more...

Installation Instructions

David from Swanzey, NH

Detergent door was not locking closed

Super simple.
Remove all screws around the stainless metal shroud inside the door. DONT remove the hinge screws.
Torx bit required.

Unplug detergent dispenser and place outer door assembly aside. Dispenser has small clips holding it in, top, bottom and sides I believe. Push these in, dispenser falls out into dishwasher.

Insert new unit, reverse all steps. Done.
Dont for get to reattach the wires! Read more...

Your Price

$135.21

Detergent Dispenser Assembly

★★★★★

(27)

PartSelect Number PS11750167

Manufacturer Part Number WPW10199696

This part releases the detergent and rinse aid into the dishwasher. Light grey in color. The detergent dispenser attaches to the inner door panel and holds the dishwasher detergent and rinse agent in a covered compartment.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

Craig from Austin, TX

latch on dispenser cover broke

Printed door assembly parts list and photo from KitchenAid website. (With the absence of instructions, it was a big help.) Remove door cover. You'll need a star driver bit. Remove the old dispenser. Note how the metal clamp and black cover sheet are positioned. Install the new dispenser. Insure the wiring harness is snapped in place. Replace the door cover. Not difficult; just some patience. One more hint ... be careful when taking the door cover off and you won't have to disconnect any other wiring. Read more...

Your Price

$70.52

Detergent and Rinse Aid Dispenser

★★★★★

(25)

PartSelect Number PS11746408

Manufacturer Part Number WP8558129

This part releases the detergent and rinse aid into the dishwasher.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

Ed from Fanwood, NJ

dispenser door was not closing

1. Remove torx screws around outer edge of inside of door.
2. Separate outer door panel from inner door panel.
3. Locate dispenser, and remove 6 hex nuts and 2 wires for solenoid.
4. Insert new dispenser and re-insert hex nuts.
5. Reinsert torx screws. Read more...

Your Price

$104.82

Dispenser

★★★★★

(11)

PartSelect Number PS11750038

Manufacturer Part Number WPW10195175

This detergent dispenser assembly is for dishwashers. Detergent dispenser assembly holds the dishwasher detergent and rinses agent in covered compartments.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

Chris from MANSFIELD, TX

Dispenser was not dispensing

I first turned the power off to the dishwasher. I then used the star bit to loosen the screws on the sides and top. Note that the 4 top screws are longer than the side screws. Once the screws were loose I used a clamp on each side to hold the door cover in place. Once the screws were removed, I released the clamps, raised the door then lifted the outer cover off. I then peeled the insulation back from the top to expose the dispenser. I used a small socket to remove the screws for the dispenser. I released the plug with a small slotted screw driver. I then exchanged the dispenser with the new unit being careful to correctly reinstall the black cover over the top. I reinstalled the door cover, being careful to tuck the insulation back in place. I then installed the screws using the clamps to hold the door in place during the reinstall. Read more...

Your Price

$134.11

Detergent and Rinse Dispenser with Cap

★★★★★

(11)

PartSelect Number PS11750655

Manufacturer Part Number WPW10224430

This part releases the detergent and rinse aid into the dishwasher.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

Jim from Sherwood, OR

The dispenser door was broken, would not close.

First I removed the (8) screws holding the front door panel on. Then I took the door panel off and unpluged the ribbon wiring so the door was free from the dishwasher. I then unpluded the wiring going to the dispensor. Then I removed the (6) screws holding the dispensor into place and then sprung the holders (2) so the dispendor could be removed. I stuck the new dispensor in its place, pushed it in so the (2) metal holders locked into place, then replaced the (6) screws, pluged the wiring into the new dospensor, pluged the ribbion wiring back in and replaced the front door panel and reinstalled the (8) screws that hold the front door into place. And then tested and everything worked fine. Read more...

Your Price

$124.21

Dishwasher Detergent Dispenser

★★★★★

(11)

PartSelect Number PS11773088

Manufacturer Part Number W11032769

Fixes these symptoms

Door latch failure
Leaking
Not cleaning dishes properly
See more...

Your Price

$138.86

Detergent Dispenser

★★★★★

(3)

PartSelect Number PS11756747

Manufacturer Part Number WPW10616003

This part releases the detergent and rinse aid into the dishwasher. **Note** this part has been redesign by manufacturer, may look and function differently than original. Rinse aid cap is NOT included. Cap is no longer needed.

Fixes these symptoms

Door latch failure
Will not dispense detergent
See more...

Installation Instructions

Jennifer from Montgomery Village, MD

Broken Latch on Detergent Dispenser

I had a broken latch on my dispenser, so had to replace the entire assembly. This is an easy repair, as the other posts have indicated. You do, however, really need a nutdriver. I undertook this project without a nutdriver and not only did it take ten times longer than it should've, but the dispenser leaked after my first attempt because I could not get the dispenser screwed in good and tight. All worked perfectly once I got the right tool, duh. The repair is done as other posters have indicated: unplug the machine, remove outer panel(s), remove six mounting screws, detach the wires attaching to the assembly, and reattach them to the new piece. **One thing not noted in other reports: there is a white plastic electrical connection on the lower right of the dispenser assembly. Mine had red wires attaching to it. To remove this from the old dispenser, you pull it straight out toward you, like a drawer from a dresser, and slot it into the new dispenser the same way. It would be quite easy to break this piece trying to get it out any other way, so use some caution. Read more...

Your Price

$11.26

COARSE CUP

PartSelect Number PS11747794

Manufacturer Part Number WP99003778

Your Price

$48.28

Detergent Dispenser Actuator

PartSelect Number PS11742310

Manufacturer Part Number WP4162568

This part releases the doors on the detergent dispenser.

Fixes these symptoms

Will not dispense detergent
See more...

Installation Instructions

Mark from Norman, OK

Detergent dispenser failed to open

Removed the door cover and replaced the bi-metal. Read more...

Your Price

$195.57

Soap Cup Dispenser Kit

PartSelect Number PS11747043

Manufacturer Part Number WP9740171

This kit comes with a new gasket and screws. Please note, this part is only meant for model numbers starting with KD18s and newer models. Model numbers starting with KD17s use a different part.

Popular KitchenAid Dishwasher Dispensers

Related Parts

Hello!

KitchenAid Dishwasher Dispensers

Find your part

Popular KitchenAid Dishwasher Dispensers

Related Parts