If your washer shakes or vibrates loudly when it reaches its max speed, check that the leveling legs are even. To ensure that the washer is firmly on the ground using all four legs, adjust the legs so...
$11.40
In Stock
Order within the next 11 hrs and your part ships today!
This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...
$65.99
In Stock
Order within the next 11 hrs and your part ships today!
This dryer drying rack is great for drying shoes and other items that cannot tumble dry. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model num...
$71.58
In Stock
Order within the next 11 hrs and your part ships today!
This is a dryer door seal, which ensures that the glass of the dryer door and its frame seal the contents of the dryer drum from your home. If you can feel warm air coming from the dryer door during t...
$71.89
In Stock
Order within the next 11 hrs and your part ships today!
This Dryer Drying Rack attaches to the inside of the dryer drum and remains stationary as the dryer turns so you can dry shoes, sweaters and other items that shouldn't be tumbled. This accessory can b...
$41.67
In Stock
Order within the next 11 hrs and your part ships today!
I purchased a stack kit from "Part select.com". The item was just what I needed to do the job. The delivery of the part was made the next morning. WOW! Excellent service! The process was completed in less than 24 hours, start to finish. Very impressed!
Removed back panel of the dryer-reached my hand to the back of the motor shaft, put 7/16 wrench on it to hold the shaft while I removed the broken pulley with pliers. Very easy fix-the tech on Utube took the entire dryer apart totally unnecessary. If that is what the factory tells its tech"s to do its no wonder why the labor charge woul
... Read mored be thru the roof.
Glass door was broken with part still in door. -put tape on glass so it would not fall on me as I dissembled door. -removed and disassembled door by removing all screws/ torx. -used shop vac to get most of the shards out then flushed with water for the rest. -used shop vac to dry door. -put back together. remembe
... Read morer to put big bulge of glass down. the rounded part of the door is the bottom. do not over tighten as the screws go into plastic. -all skill levels can do this job. it will only go together one way. the glass has a notch bulge that alines with the bracket. worst case is you have to put it together 3 times before you get it right. the door is reversible so it can open either to the right or the left giving you four combinations on how to install the glass. don't over tighten the phillips as they go into plastic. Go for it.
