This door switch is for dishwashers.
The door switch detects when the door is closed so the dishwasher can start.
Unplug the dishwasher or shut off the house circuit breaker before installing th...
$71.87
In Stock
Order within the next 4 hrs and your part ships today!
This part is the replacement drain check valve for your dishwasher. It is made of black plastic and is approximately 1-1/4 inches by 1-1/4 inches. The round section of the check valve is approximately...
$25.07
In Stock
Order within the next 4 hrs and your part ships today!
This is a leak sensor designed for use with a range of Samsung dishwashers. This sensor is designed to detect if water begins leaking from the water supply. If/when it detects a leak, it stops the wat...
$28.67
In Stock
Order within the next 4 hrs and your part ships today!
This is not a repair for the faint of heart. You will have to pretty much disassemble the entire dishwasher to replace the main pump assembly. And it’s not cheap, between the pump assembly and the hose...it was over $300...
This dishwasher is Junk...been through 2 motherboards, plastic internal spray arms...and finally a pump a
... Read moressembly...if you own one and the pump begins to leak....shorts the pump motor out....if it gets this far...but a new dishwasher.
The install definitely takes a bit more than the video I watched but in the end all was fine. The electrical and hose connections are nothing but getting the three screws and retainers isn't as easy as shown in the video I watched and getting them back in is even worse. My hands aren't small but they're not huge either. You'll need multip
... Read morele phillips head screwdrivers. All a #2 head, with one stubby, one about 6" and one long one with about 8" or more of shaft on the screwdriver to remove the screws. Also take pictures if possible with your phone for reconnecting all your wiring harnesses will prove helpful. The only other difficult part of doing it by yourself is compressing the new sump seal enough to get the three nylon retainer clips back into place. There is really need or room for two people on any part of this other than at that point. If you could have somebody push down on the pump unit from inside while you install the retainers it would make it so much easier but I managed. Other than that not a big deal. Good luck!
Repair was fairly simple. Remove torx screws making sure that front control panel does not separate too much from door panel. Not a big deal if it does, just a little more work when putting it back together. Replacing broken part is plug and play. Reseat door panel and control panel and secure with previously removed torx screws. I’ve pro
... Read morebably made it sound a bit more complicated than is really is.
