Thermal Fuse 134711401

Hi Mark, Thank you for the question. That E66 error code means the exhaust thermal limiter is tripped or that you have a wiring failure in that circuit. That fuse is on the outlet exhaust tube. You can check the continuity of the thermal limiter fuse using a volt/ohm meter. Hope this helps!

Hello Tom, thank you for your question. The limiter is located on the back of the dryer, on the side of the heater pan. It is item # 8 on the Upper cabinet/drum heater diagram. I hope this helps!

Hello Jorge, thank you for your question. We would recommend testing the Part Number: 134587700 Control Thermistor and the two thermal fuses PartSelect Number: PS7783961 and PartSelect Number: PS4704883. If these are tested and are not bad, you will want to check the burner parts which would be the igniter, coils, flame sensor and valve. I hope this helps!

Hello Dan, thank you for inquiring. For this symptom you will want to replace either the 'M' Series Ignition Coil Kit part PS470049, the Flame Sensor part PS459818, or the Control Thermistor part PS1149368. We hope this helps.

Hello Travis, thank you for contacting us. You will want to consider replacing either the High Limit Thermostat part number PS446428 or the Control Thermistor part number PS1149368 for your model to fix this. Good luck with your repair!

Hello Travis, Thank you for the question. there is a second Hi Limit Thermostat, PartSelect Number PS8691862. I looked up the part and it is listed as No Longer Available/Discontinued sorry. There are no part substitutions listed. My suggestion here would be to call the manufacturer and see if they can provide you with a substitution for these part numbers. Hope this helps!

Hello Orville, Thank you for the question. I suggest replacing the Thermister PartSelect Number PS1149368 at the same time as the fuse. If you are also getting the door open error you may also need to test the Door Switch PartSelect Number PS2367765. Hope this helps!

Hi Mary, thank you for your question. Looking at your model information there are a few parts that you should take out and test to see which one is giving you the issue. The first parts to check in this case would be all of your thermostats and thermal fuses. You can test those parts with a multi meter and they should be reading 0 ohms to be working correctly. If those parts are fine, you should then go on to testing your heating element as well. You can also test that with a multi meter and it should be reading between 0 - 50 ohms. Something else you should also check would be your filter and ducts. Make sure there is absolutely no blockage that would restrict air flow in your appliance. I hope that helps. Good luck with your repair.

Hello Stewart, Thank you for the question. We suggest testing the PartSelect Number PS2349395 Thermal Fuse for continuity with a Multimeter. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hola Karla, gracias por contactarnos. He investigado el modelo que ha proporcionado y he encontrado que la pieza que busca es el número de PartSelect PS418726. ¡Espero que esto ayude!