Models > CAQE7011KB0

CAQE7011KB0 Frigidaire Dryer - Overview

Sections of the CAQE7011KB0

[Viewing 7 of 7]

Manuals & Care Guides for CAQE7011KB0

Click to download
Keep searches simple, eg. "belt" or "pump".
High Limit Thermostat – Part Number: 3204267
High Limit Thermostat
★★★★★
★★★★★
(2)
PartSelect #: PS446428
Manufacturer #: 3204267
This high limit thermostat is used in a dryer and monitors the temperature to make sure it does not exceed 260 degrees Fahrenheit. When your dryer temperature reaches 260 it will cut it out and only c...
$85.14
  In Stock
Dryer Door Catch – Part Number: 131658820
Dryer Door Catch
★★★★★
★★★★★
(10)
PartSelect #: PS2367736
Manufacturer #: 131658820
This door catch is used for a washer and dryer unit. The catch holds the door strike to keep the door securely closed during a cycle. If your door will not close or your dryer will not start, replacin...
$19.27
  In Stock
Door Strike – Part Number: 5303207102
Door Strike
★★★★★
★★★★★
(7)
PartSelect #: PS455020
Manufacturer #: 5303207102
The door strike is attached to the door of your dryer and holds the door closed. If your dryer door is not closing, this might be due to the door strike needing to be replaced. This is a simple repair...
$21.75
  In Stock
Blower Housing with Blower Wheel – Part Number: 131775600
Blower Housing with Blower Wheel
★★★★★
★★★★★
(14)
PartSelect #: PS418726
Manufacturer #: 131775600
***Please Note: This part is a substituted part by the manufacturer. It may appear different, but should still work with your appliance.
$122.08
  In Stock
Screw – Part Number: 131302800
Screw
PartSelect #: PS417463
Manufacturer #: 131302800
This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. T...
$24.35
  In Stock
SCREW – Part Number: 131168200
SCREW
PartSelect #: PS417085
Manufacturer #: 131168200
Sold individually.
$25.42
  In Stock
Control Thermistor – Part Number: 134587700
Control Thermistor
★★★★★
★★★★★
(2)
PartSelect #: PS1149368
Manufacturer #: 134587700
This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.
$45.35
  In Stock
High Temperature Adhesive – Part Number: 5308027429
High Temperature Adhesive
PartSelect #: PS474458
Manufacturer #: 5308027429
This high temperature adhesive is used for installing felt and rubber seals on dryers. The tube contains 1 ounce of product. This adhesive is made to withstand extremely hot temperatures. Before apply...
$52.32
  In Stock
GASKET – Part Number: 137553402
GASKET
★★★★★
★★★★★
(8)
PartSelect #: PS8689127
Manufacturer #: 137553402
This is a gasket, but you may also know it as a door seal, for your dryer. This part prevents heat loss during a drying cycle by keeping the area around the door sealed. This gasket is all black, and ...
$63.24
  In Stock
Lint Filter - White – Part Number: 134701410
Lint Filter - White
★★★★★
★★★★★
(5)
PartSelect #: PS2363394
Manufacturer #: 134701410
$61.43
  In Stock
Thermal Fuse – Part Number: 137032600
Thermal Fuse
★★★★★
★★★★★
(2)
PartSelect #: PS2349395
Manufacturer #: 137032600
$46.23
  In Stock
ROLLER KIT – Part Number: 5304523155
ROLLER KIT
PartSelect #: PS12746506
Manufacturer #: 5304523155
This is a genuine replacement drum roller for a dryer. This part includes a roller which has an axle and two tri-rings. The dryer drum roller holds the drum in place while it rotates on the dryer supp...
$57.82
  Special Order

Questions And Answers for CAQE7011KB0

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the CAQE7011KB0

[Viewing 9 of 9]
Door won’t close
Fixed by
these parts
Show All
No heat or not enough heat
Fixed by
these parts
Show All
Noisy
Fixed by
these parts
Show All
Will Not Start
Fixed by
these parts
Show All
Takes too long to dry
Fixed by
these parts
Show All
Too hot
Fixed by
these parts
Show All
Shuts off too soon
Fixed by
these parts
Show All
Marks left on clothes
Fixed by
these parts
Show All
Will not tumble
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Noisy Dryer
When I described the noise to a YouTube appliance diagnostician, I was directed to check the felt seals front and back of the rotating drum for wear, tears, or foreign objects. As it happens the felt seals looked find and there were foreign objects so, not wanting to disassemble and reassemble the dryer more than I had, I ended up replacing all the replaceable moving parts that I considered possible culprits: The idler tension spring, the idler tension bracket (which includes a nylon pulley wheel), the drum belt, the five rubber-tipped bearings that support the drum and keep it in place, and the foam seal on the blower housing which seemed a little brittle and old, as well as high-temperature adhesive for the latter. The instructional videos here and on YouTube were extremely helpful (I doubt that I would have attempted this job at all, had I not watched these ahead of time). The most time-consuming aspect was waiting for the arrival of the parts as I didn't order them all at the same time or all from the same place (I ordered from whomever could ship me a given part the fastest. Disassembly took less than an hour. Re-assembly with the new parts in place took about the same but was a little more awkward because this appliance sits in a very narrow closet and it's difficult to ensure that the 4" flexible duct stays in place when sliding the appliance back into the closet. No regrets. Now I know the basics if this dryer needs attention in future and I also know all the parts that I can eliminate as suspects in any future maintenance (the parts that I replaced)
Parts Used:
Belt ROLLER KIT
  • Philip from Oakland, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
25 of 31 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer cut off before the clothes were dry.
All the symptoms indicated the thermister (located in the exhaust air stream of the dryer) was the problem. Pulled the lower panel off the dryer. Took out the two lower screws holding the door panel on so I could pull the front panel out just enough to get a screwdriver on the screws holding the thermister on. Unhooked the two wires connected to it and hooked them to the new thermister(no need to observe polarity). Put the new thermister in, screwed the door panel back down, put the lower panel on and started drying clothes.
Parts Used:
Control Thermistor
  • Don from RUIDOSO, NM
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
14 of 20 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Blower wheel was raddling
The blower wheel was a bit difficult, but manigable to do yourself.
Parts Used:
Blower Housing with Blower Wheel
  • jena from loganville, GA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
22 of 48 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!