Average Repair Rating: 4.4 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
ignition module was burnt out
on my cooktop I removed the burner grates then I took the burners out removed the two screws from each burner holder lifted the top to uncover the works inside took all the wire connections from the module removed the module by moving back and forth put new module in and reversed the steps BUT MOST IMPORTANT I PULLED THE PLUG BEFORE
... Read moreI DID ANYTHING
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Pete
November 21, 2018
I have a Maytag cook top unit. How do i remove the glass control panel, trim control, and push clip. I need to replace the burner switch # wp7403p367 60. I would appreciate any help i can get with this. Thank you!
For model number CSG5600CAD
Hi Pete, thank you for your question. You may need to take a putty knife to pop the trim out of place. I could suggest putting a bit of tape over the blade of the knife to dull it so that you do not scratch your appliance. However the trim just pops out of place and the panel underneath of that does the same. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Brian
August 20, 2019
When I turn on the knob to light one burner, the igniter is not sparking. However, if I turn on a knob for the different burner, the igniter sparks on the one that wasn't sparking. Do you know what could be causing this?
For model number csg7000cae
Hello Brian,
Thanks for your question!
The problem is likely the spark ignition module - PartSelect Number: PS2003170 is not functioning properly.
We hope this helps!
Was this helpful?
Thank you for voting!
Joseph
January 22, 2018
How do I remove the burner switch from the cooktop
For model number CSG7000
Hi Joseph,
Thank you for your question. You will have to remove your cooktop from your counter. Once you do that you should be able to unscrew the screws that keep your glass top attached to the bottom of the cooktop. Then you will be able remove the switch from your appliance and install the new one. I hope that helps. Good luck with your repair.
