Tappan Refrigerator Trays and Shelves

Tappan Appliance Parts
Shop By Part Type

Popular Tappan Refrigerator Trays and Shelves

Your Price
$30.85
  In Stock
Door Rack
★★★★★
★★★★★
(60)
PartSelect Number PS735091
Manufacturer Part Number 240535101
The Door Rack (also known as a retainer bar) is a 23" white plastic part used to hold small items inside the fridge door. If broken, it should be replaced. Refer to your user manual and model number to determine if this part is correct for you. This is a simple part to repair and should not require any tools. Most customers found it to be very easy to simply snap the old rack out of place and snap the new one back in, making sure the locking tabs are secure. This part is sold individually and not as a part of a kit. It is certified by the original manufacturer.
Fixes these symptoms
Installation Instructions
Jane from Owosso, MI
broken refrigerator door shelves
snapped right on and removed screws, insert and replace screws. Read more...
Your Price
$35.20
  In Stock
Door Rack - White
★★★★★
★★★★★
(12)
PartSelect Number PS734991
Manufacturer Part Number 240535201
The door rack shelf bar has the end caps to attach it to the door already attached to the end of the bar.
Installation Instructions
Jeff from New Yrok, NY
the shelf bar broke
I popped the new one in. My cat could have done it Read more...
Your Price
$6.32
  In Stock
Door Shelf End Cap - Left or Right Side
★★★★★
★★★★★
(9)
PartSelect Number PS422925
Manufacturer Part Number 215473602
The door shelf end cap, or door bin support, secures the rack in a refrigerator or freezer door. Note that this fits on either the left or right hand side. If the end caps of your refrigerator or freezer are broken or cracked, or if your food retainer bar is not staying in place, then replacing the door support can solve this problem. No tools are needed for this repair project. To repair, first remove the end cap by pushing upward or downwards to slide it out the end of the rail. Next, replace with new end cap and line it up to clip it back onto the rail. It comes in white and measures about two inches high. Remember to wear gloves for safety.
Installation Instructions
Lynn from New York,, NY
My electric bill was super high. $450 for 1 month for a 1bdrm apt in NY city
I took a look at the web site where I purchased the parts, then I took a look at the paper enclosed with the order. Thankfully, I have a battery operated screw driver since there are so many screws. There are plenty of screws in my refrigerator and freezer doors. I thought that since my old door gaskets were all chewed up looking, if I changed them, the 10 year old air conditioners and the old fashioned light bulbs to instant on energy saver light bulbs, the electric bill would become more manageable.

The refrigerator and freezer door gaskets were the first step. They were easy to swap out. You just need to empty the door of all food items, then pull back the old gasket to see the screws. There are alot of them. You should leave 2 loosened screws on each side of the refrigerator door to hold the panel in place while you work and remove the rest. Then you can remove the old gasket and slide the new one into place. Make sure as you tighten the screws and replace the ones you removed, the new gasket fits into the door panel groove securely and is in place as you tighen the screws. Make sure it is in place all the way around the door as you work. You repeat the procedure for the freezer using only one loosened screw on each side to keep the interior panel in place while you work. It takes some time due to the number of screws, but the work is pretty easy. I never even broke a nail.

The end caps for the shelf bars just snap into place just as the old ones can be snapped out with a bit of pressure. They do not have to be wrestled and you need to work carefully so that you do not break them. (I ordered an extra just in case, but I didn't need it. I will have it in case I need it in the future)

My electric bill dropped from $450 to $110 a month with all the improvements I made. Thank you Part Select for taking the fear of screwing it up, out of the repair process and making it manageable. I can afford my electric bill now. Thanks for your help.
Read more...
Your Price
$6.28
  In Stock
Door Shelf End Cap - Left or Right Side
★★★★★
★★★★★
(8)
PartSelect Number PS422444
Manufacturer Part Number 215267701
This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf. It is white in color, made of plastic material and measures about 2 inches high by 3 inches deep. This might need to be replaced if it has broken or worn over time. This repair requires no tools. You will need to open your fridge, pull upwards on the existing end cap, and pull outwards. There is a locking tab on either end so it does not matter if the top or bottom comes out first. Slide the new end cap onto the rail and it is installed.
Installation Instructions
David from Fleetwood, PA
Freezer / refrigerator warm (not defrosting)
I checked the defrost timer (bottom front of the freezer / outside). I advanced it to send it into the defrost cycle. The heating elements in the freezer (behind the panel) did not heat up. I cut the wires going to the defrost thermostat. Turned the power back on, made sure the defrost timer was still in the defrost cycle and checked the voltage at the wires to the defrost thermostat (before the heating elements). There was power / voltage there. I jumped out / bypassed the defrost thermostat turned the power back on and the heating elements came on. The problem was the defrost thermostat. So I replaced it with a new one from PartSelect.com. How it works...
When the defrost timer is advanced to the defrost cycle the switch closes sending power to the defrost thermostat. If the temperature is low enough, the defrost thermostat switch will close and sends power to the heating elements. When the temperature rises high enough about 55 degrees the switch at the thermostat will open and the heating elements will turn off (not allowing the freezer temperature to get too high, just enough to defrost the coil). The refrigerator will turn back on when the timer advances. The defrost timer will defrost every 8-12 hours.
Read more...
Your Price
$49.47
  In Stock
Door Shelf Retainer Bar - Cut to Fit
★★★★★
★★★★★
(2)
PartSelect Number PS422630
Manufacturer Part Number 215366002
This is a white cut-to-fit door shelf retainer bar.
Installation Instructions
David from Fleetwood, PA
Freezer / refrigerator warm (not defrosting)
I checked the defrost timer (bottom front of the freezer / outside). I advanced it to send it into the defrost cycle. The heating elements in the freezer (behind the panel) did not heat up. I cut the wires going to the defrost thermostat. Turned the power back on, made sure the defrost timer was still in the defrost cycle and checked the voltage at the wires to the defrost thermostat (before the heating elements). There was power / voltage there. I jumped out / bypassed the defrost thermostat turned the power back on and the heating elements came on. The problem was the defrost thermostat. So I replaced it with a new one from PartSelect.com. How it works...
When the defrost timer is advanced to the defrost cycle the switch closes sending power to the defrost thermostat. If the temperature is low enough, the defrost thermostat switch will close and sends power to the heating elements. When the temperature rises high enough about 55 degrees the switch at the thermostat will open and the heating elements will turn off (not allowing the freezer temperature to get too high, just enough to defrost the coil). The refrigerator will turn back on when the timer advances. The defrost timer will defrost every 8-12 hours.
Read more...
Your Price
$16.58
  In Stock
Door Shelf Retainer Bar End Cap - Left or Right Side
★★★★★
★★★★★
(2)
PartSelect Number PS428664
Manufacturer Part Number 218758602
It can be used with either the right side or the left side refrigerator and freezer door shelves.
Installation Instructions
Thomas C. from Findlay, OH
Replaced the broken door shelf bars.
The old shelf rails in the frige and freezer were broken and would not stay in. I had to cut the new rail to length, glue the brackets on and pop the new ones in.

I got my parts the day after I ordered them.
Read more...
Your Price
$34.25
  On Order
Door Rack
★★★★★
★★★★★
(1)
PartSelect Number PS735092
Manufacturer Part Number 240535001
This part is the replacement door rack for your refrigerator freezer. It is made of white plastic and is approximately 23 inches by 5 inches in size. The door rack connects to your freezer door and allows you to store items on the door shelf, without the items falling out when you open or close the door. The main reason to replace the door rack would be if it is cracked, broken, or missing. To replace the door rack, carefully pop it out of the guide holes in the freezer door and snap the new rack into place. This part is sold individually and is a genuine OEM part.
Installation Instructions
Ron from GREELEY, CO
Handle broke
Remove old handle and screws and replaced Read more...
Your Price
$10.85
  In Stock
Door Shelf End Cap - Left Side
★★★★★
★★★★★
(3)
PartSelect Number PS467739
Manufacturer Part Number 5303324302
This is the door shelf end cap for your refrigerator. It connects to the refrigerator door and keeps the door bar in place. Your refrigerator will have two shelf end caps, one for the right side and one for the left. This part is the left side door shelf end cap. It is made of white plastic and is a little over two inches long. This is an OEM part from the manufacturer and is sold individually.
Installation Instructions
Nell from New Orleans, LA
Door shelf retainer bar end caps broke off at insertion point.
Removed plastic male parts. Inserted new end caps onto old retainer bar. Inserted all into door. A snap, but I didn't need to order the retainer bar after all - the old one was the perfect fit and the one I ordered was way too long. I returned the new retainer bar, and the shipping was more expensive than the part. Read more...
Your Price
$37.90
  On Order
Table-Type Freezer Wire Shelf
★★★★★
★★★★★
(1)
PartSelect Number PS460028
Manufacturer Part Number 5303282284
Sold individually. NOTE: For 18 cubic feet refrigerator model order part # 240358005 for the shelf and part# 3201150 end caps, quantity 4.
Door Shelf End Cap - Right Side
★★★★★
★★★★★
(4)
PartSelect Number PS447375
Manufacturer Part Number 3206150
This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.
Installation Instructions
Nell from New Orleans, LA
Door shelf retainer bar end caps broke off at insertion point.
Removed plastic male parts. Inserted new end caps onto old retainer bar. Inserted all into door. A snap, but I didn't need to order the retainer bar after all - the old one was the perfect fit and the one I ordered was way too long. I returned the new retainer bar, and the shipping was more expensive than the part. Read more...

Related Parts