Tappan Range Lights and Bulbs

Videos!

Your Price

$10.43

Tappan Range Light Lens Indicator

★★★★★

4 Reviews

PartSelect Number PS2342816

Manufacturer Part Number 316557300

Installation Instructions

Kathy from NEW BERN, NC

Burner indicator light lense broke off

The light apparatus was loose behind the panel. Remove the remaining part of the lens. Install the new lens from the outside of the panel and hold it in position, protruding into the inside of the panel. Slide the light apparatus onto the lens from the inside, allowing the bracket to hold it in place - it will be spring loaded, which will hold it in place. Read more...

Your Price

$11.23

Tappan Range Indicator Light Lens

★★★★★

5 Reviews

PartSelect Number PS1765368

Manufacturer Part Number 318228310

This is a red indicator light lens for an oven that covers the indicator light for the surface element. The indicator light signifies when the element is on and heated. This part is sold individually. It is recommended to check other red indicator lights in case they need to be replaced because they often wear at the same rate. It is difficult to see the light without the red lens. This part does not include the light. If your light does not illuminate, you may want to consider ordering the light as well. Tools required for this repair are a 1/4 inch nut driver and a stubby Phillips screwdriver.

Installation Instructions

Carol from Houma, LA

Lens missing for burner "on" indication

Lifted the oven top, removed the controls cover, slipped the lens into the hole and slid the light holder device onto the lens Read more...

Your Price

$46.67

Tappan Range Light Indicator - 125v

PartSelect Number PS436960

Manufacturer Part Number 316022500

Videos!

Your Price

$46.58

Tappan Range Oven Light Socket

★★★★★

4 Reviews

PartSelect Number PS439060

Manufacturer Part Number 316116400

The oven light socket allows you to screw in a light bulb so that you can see the inside of your oven. The light socket is located in the back of your oven, so you will need to remove the back panel to access the socket for the repair. You will also need to remove the current light bulb and the light lens cover so that the old socket can be removed. As you will be working around electrical circuits for this repair, be sure to disconnect the power source from the oven before you begin work on the oven.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Paul from Spokane Valley, WA

Oven light receptacle broken - bulb base broke off

Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall. Read more...