Poulan Pole Saw Parts

Shop By Appliance Type Shop By Part Type

Popular Poulan Pole Saw Parts

Bulb-Purge "snap-in" – Part Number: 530047721

Your Price

$6.21

Poulan Pole Saw Bulb-Purge "snap-in"

PartSelect Number PS9471212

Manufacturer Part Number 530047721

This primer bulb, also known as a purge bulb, is used to push more fuel from the fuel tank into the carburetor of your small engine equipment, to help the engine start easier. Over time and through extended use and exposure to gas and oil, the bulb of the primer will eventually lose its elasticity and crack or break. This bulb is made of plastic and can be replaced by accessing the ignition system. Disconnect the fuel lines and pop out the bulb with a set of pliers, and once you pop in the new bulb, you just reconnect the fuel lines. This bulb is compatible with a variety of makes and models of small engine equipment and is sold as an individual part.

Installation Instructions

Robert from MANVILLE, NJ

Replace the fuel lines

Replaced all fuel lines. Followed instructions found on Partselect.com, which said to insert cut fuel line in tank and use forceps to reach back in the tank and pull the fuel line through. The problem was that I did not have forceps, or needle nosed pliers that could reach the end of the hose.

Instead of running the line into the tank, I found another suggestion online to run the line from inside the tank outward, allowing me to grab the line with any pliers and thread it. The way I did this was used about a foot length of 14 gauge copper wire. Put an inch or two into the hose (that has been cut on an angle), and use a little black tape to secure the hose on the wire. Now you should be able to route the stiff wire from inside the tank to the fuel hole in the tank. Fish the wire through, and it should be enough to get the tapered end through the tank. Pull the copper wire, mine came out, but there was enough of the hose exposed on the outside of the tank for me to grab with pliers and pull it through. Read more...

Kit - Bar Adjust – Part Number: 530069611

Your Price

$4.99

Poulan Pole Saw Kit - Bar Adjust

PartSelect Number PS9472355

Manufacturer Part Number 530069611

This Chain Bar Adjuster kit is a kit which contains all necessary hardware for adjusting a chain bar on a chain saw. Installation is rated as "Easy" and requires a screwdriver, wrench set and socket set. This part comes directly from the manufacturer.

Your Price

$7.46

Poulan Pole Saw Spring-Starter

PartSelect Number PS9482323

Manufacturer Part Number 545008014

Assembly-Fuel cap – Part Number: 578931605

Your Price

$8.71

Poulan Pole Saw Assembly-Fuel cap

★★★★★

1 Review

PartSelect Number PS11811507

Manufacturer Part Number 578931605

Nut - Bar Mounting – Part Number: 530015917

Your Price

$3.99

Poulan Pole Saw Nut - Bar Mounting

PartSelect Number PS9469166

Manufacturer Part Number 530015917

The OEM Mounting Bar Nut is a nut used to install a mounting bar to your machine. Installation requires a wrench set and socket set, and is rated as "Easy". This nut attaches to the chainbar studs.