SE1000 Maytag - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
leaking from tub
I watched the online video that was supplied when I ordered the part and it made all the difference in a successful repair. Thank you for having such a complete solution!
Parts Used:
-
John from Dedham, MA
-
Difficulty Level:Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
very squeaky dryer under load
My take apart, fix-it son, Had it all apart and fixed in under 2 hrs. Thanks for quick delivery.
Parts Used:
-
Dianne from Pembroke, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:1- 2 hours
Was this instruction helpful to you?
Thank you for voting!
A water leak during the wash cycle
I watched the video and it was just a easy as the video stated. This part was stated as a common problem causing the water leak. I was doubtful after looking at the old part because there were no visible signs of wear, but decided to go along with the guidance and sure enough, it fixed the leak. It was a minor cost and an easy fix.
Parts Used:
-
Anne from Shelburne Falls, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Siphon Break leaked on spin cycle.
Remove front cover lower screws(2) with Phillips screwdriver. Remove Upperlid Bolts (left & right side) under top cover , Flip lid Back to access siphon break (rear right corner) Remove drain hose clamp, Remove clamp at bottom of siphon break. Remove (4) screws rear of washer around drain hose elbow. Remove siphon break, reinstall in reverse order. (Make Sure new siphon break washer is installed in siphon break.
Parts Used:
-
Phil from Portland, OR
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
No agiation on wash cycle
Remove screw on lower side of agiator, pullout agiator. Remove top washer clip and washer. Remove damaged seal and broken seal spring. Clean out debree and soak drum seal housing with WD40.Make sure shart will turn, iastall new spring seal and agiator.
Parts Used:
-
Phil from Portland, OR
-
Difficulty Level:Easy
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!