HTWP1400F2WW Hotpoint Washer - Instructions

Removed front panel, laid washer on backside. Turned pulled while holding with screwdriver. Belt is very tight on pulley and motor.

I just did a google search and found a video that shows to use a zip tie to hold the belt to the big pulley and simply turn the drum and the belt goes right on. Then cut the zip tie off and you are ready to go. Took all of 3 minutes to change the belt from start to finish.

Installation went okay but still only get cold water fill

With the instructions found online, this was a quick easy repair. I used youtube to have video to show the method. Used rope to pull up agitator, used wrench to loosen bolt and then put back together. Part was delivered really fast, I recommend Partselect.com for the parts you need!

First I removed the softener dispenser then I grabbed the agitator at the bottom and with a tug completely removed it. I took the new part out of the box and lowered it down over the hub in the bottom of the washer and gently pushed it until it snapped in place. Then I re-installed the old fabric softener dispenser and the job was complete.

I was frantically trying to find a cheap washer to replace the one that "broke". Fortunately, my son's roommate is a maintenance technician. He diagnosed the problem immediately. I googled the issue, found the part, ordered it and received delivery of the part in 3 days. It took all of 5 minutes to replace the part and reassemble the washer. Now on to the 15 loads of laundry that have been stacking up!

We couldn't get a repair to come out - were told to buy a new because it would cost too much to fix. I did not agree. I pulled the agitator off and discovered it was not working and the agitator coupler was spinning. I ordered both and put them in myself. My washer now worked like new! All for less than $100. The service guy wouldn't eve come out for less than $175 and that did not include parts!

order part. replace

I watched the video you provided and I could't believe how simple it was. I'm 67 yrs old and I just followed the video instructions.

Changing the belt didn't solve anything. We took the console apart and there is a Troubleshooting Guide folded up in there. It has a Code List and a sequence to follow to determine the trouble codes. While there was nothing wrong as far as coding, it did lead us to confirm the discharge pump WAS working, even though there was no water coming out. The discharge hose was plugged.

Couldn't get the agitator off by pulling up, then thought about it and got 2 carpenter claw hammers, inserted one on each side and puled up evenly on both and off she came. Sprayed the slots with WD Forty and popped the new on. THANKS saved us a lot of money!!!

The pressure hose was my problem. It seemed to be connected and did not have any visible holes. When I blew in it there did not seem to be a leak. After trying some tubing from the hardware store that worked sometimes but not always I decided to get the manufacturer part. I realize now that the pressure has to be exact for the switch to work correctly. You can check the switch by blowing into the hose from the tub end, it should start to cycle once the pressure changes. If the switch works try replacing the hose even if you can't find a leak and use the manufacture part to get the correct pressure. Good Luck.

The belt is very tight. Use a zip tie to old the belt on as you work it around the large pulley. Once it is on remove zip tie and turn the pulley enough times to line up the belt evenly then your done.

Easy I followed the video. It took approx. 15 Min. Thanks to the video I feel like I can repair anything. This is not the first appliance I fixed. Thanks to parts select.

Pull the Agitator out by hand no tools where needed. Took Fabric Softer dispenser off put it on new Agitator. Pushed the new Agitator on. Repair done. Sure am happy I did it myself. Service charge from repair company would have been a lot more then $50.00.