GLD6210L15BB General Electric Dishwasher - Instructions

Laid on floor remove two small bolts with nutdriver,loose water line with wrench,remove other water line with pliers.Remove water inlet valve and replace with new one

Wow, could not have been easier. The suggested repair stated that the water inlet valve was the problem 93% of the time. And, it was spot on. It was the exact same replacement part. And, once installed, it worked like a charm. I have bookmarked this website, and will use it for all future appliance repair. I simply could not be more pleased. It was a breeze. Thanks,

Piece of cake! Very easy. Thanks for quick shipment. Appreciate it.

To remove the old circulation pump part please note it had a left hand thread that was not clearly identified in the instructions. Check the direction of all threads before trying to disassemble the old parts. ie check the new parts and thread direction to ease disassembly of old unit. Main ring has left hand thread.

Remove front shields on bottom of dishwasher. Shut off dishwasher and electricity. Unplug electric connection. Unscrew brace holder screws on front. Remove clamped on hose at back of valve. Unscrew valve from copper water pipe. Screw on new valve to copper water pipe. Put on clamped hose. Screw on bracket. Plug in electric connection.

Put rack in place and snapped new one in.

Replaced pumped with new pump and now its not leaking and dishwasher is working great now.

Quick and easy...a 7 yr old could have done it.

The problem started with my dishes slowly becoming less and less clean wash after wash. To diagnose the problem, I turned on the dishwasher and waited for the clean cycle to start. After it did I opened the door and peaked inside to see the top and bottom spray arms were moving but not the middle one. I took it out and stuck it under the faucet to make sure it wasn't clogged and everything seemed good. So after much deliberations, I decided that it must be the pump, so I replaced it. NOPE! That was costly. I then read something on the internet about how the middle arm has two jets on the bottom so I checked mine and sure enough, they were clogged. I tried to clean it but I could not get the junk out. So I decided to but the spray arm and the arm holder(because I damaged it)and now my dishwasher runs great.

My wife said the door broke; we need a new dishwasher. It is not worth a $100 repair out of warranty. I checked this site the springs were about $4 each. When they arrived I unscrewed two screws holding the dishwasher to the counter; carefully pulled the dishwasher out from under the counter; found the broken spring replaced it and for good measure I also replaced the old working spring on the other side. The door now works fine. Total time less than a half an hour.

I replaced the upper rack sliding components. It was pretty straightforward.