remove star screws holding inside door panel. remove plastic cover that protects latch assembly. hook one end of spring on stationary pin on inside of slider bar. Hook other end of spring on pin on slider bar. replace cover and door panel.
Replaced door gasget took 5 minutes tops. Ran cycle and still had leak. Called local repair person. After thoroughly checking out the dishwasher and running soapless cycle determined problem to be soap build up over time. He ran a commercial cleaner through a complete pots and pan cycle. No more suds and no more leak repair complete. Did not actually need door gagset but it was super easy to change and delivery service was great.
I watched the video link sent in an email and followed exactly what they did in the video. I removed the star head screws holding the door liner in place. Then removed the protective cover on the inside. I disengaged the component holding the latch in place. I replace the component that holds the latch in place and then snapped the new latch in place. I turned the dishwasher dial until the prongs were fully retracted. I replace the protective cover and then put the door cover back in place. I initially only placed the left bottom star head screw until I was sure that the latch was going to release. I tested that it was working properly by slowly turning the dial on the dishwasher control. Once I knew it was working I replaced the rest of the screws.
water leak at pump house and drive motor shaft interface
after removeing the mounting and trim screws,water lines and associated wiring, the unit slide easily from under the counter then the fun began. After several years of being exposed to the terrible water here the parts had become covered in lyme scale. to make a long story short, most of the parts came out with minor difficulty however the pump motor shaft had corroded and lodged into the pump impellar. This made removal of the pump motor impossible with out cutting off the end of the impellar and driving the pump motor shaft out. This is NOT something you want to do. It seems the engineer who designed the pump motor had it's casing made of plastic. Driving the pump motor shaft out of the impellar caused the back of the motor houseing to break thus rendering the pump motor useless. Lesson: If it becomes necessary to cut off the impellar of in the pump housing you must completely split the impellar in two parts. This I repeat is NOT something you want to do. I recommend replaceing both motor and pump assembly as a unit.
seal was leaking from not being used for over a year
turn off power to unit open the front to remove washer arm and nut turn unit on its front looseing the pump assembly from connections and motor replaced parts reversed order of assembly done cost was much cheaper than other places one place wanted $160.00 another place wanted $130.00 with your parts i fixed it for $61.00 that included two day shipping thanks i will shop here again
Got the new door and tried to put it on. The door went on very easily. However, there's a spring that opens the door when the main wash cycle comes around. I never did get that spring right. None of the drawings showed the correct position and after an hour of trying to get it to work right, I gave up. The door comes open slightly (but not because of the spring) when it's time, and the liquid soap runs out due to gravity. But I wouldn't try to use soap powder because the door doesn't come open far enough.
Very easy repair. I gently removed the rubber seal at the top of the tub. here I found the 2 holes to screw the new plate into place. Put the seal back over the hole and job done. Thanks for all the help from the very supportive staff. Yes, a woman did this repair. Dishwasher working like brand new!