Models > AFI2538AEB > Instructions

AFI2538AEB Refrigerator - Instructions

All Instructions for the AFI2538AEB
811 - 825 of 863
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
broke the tab on the right side, for the second time.....
Removed the fruit and veggie drawers & the deli (pantry) drawer. (Tim from Littleton CO helped me in this when he described his experience)......what helped me this time is before I put the side panel all the way into its' home position, I fastened the deli lid in place, being sure to not put any strain on the tab that I broke the last time. This go around I ordered two of these side panels just in case. I received my parts in two days. thanks!!!
Parts Used:
Pantry End Cap Kit, LH and RH
  • paul from westminstrer, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Wheel Broke
Grind rivet head off , install rivet tap end
Parts Used:
Single Roller Roller Pin
  • kenneth e. from phx., AZ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
R & R the overload/relay start capacitor in a Kenmore refrigerator.
After unplugging the refrigerator, I removed the lower rear access panel that exposed the condenser and the overload/relay start capacitor with 1/4" nut driver (6 total). Next, I unplugged the wire harness and spring loaded keeper with needle nose pliers. Then I pulled the overload/relay start capacitor out of the 3 pronged male receptor located on the side of the condenser and plugged in the new one. Replaced the keeper, plugged the harness back in, and replaced the panel. Very easy fix.
Parts Used:
Compressor Start Device and Capacitor
  • David from Grass Valley, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Pantry end cap tab broke off. Right side. Left side broke last year. Very poor design.
Removed veggie draws and glass tray.
Parts Used:
Pantry End Cap Kit, LH and RH
  • Candace from Albuquerque, NM
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Hinge pin broke on end panel
Part arrived in 2 days. Repair very easy
Parts Used:
Pantry End Cap Kit, LH and RH
  • Stanley from Binghamton, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
center rail that holds the veggie bins broke
Ordered new center rail which arrived next day (!) my husband took the shelf out, inserted new rail into slots, replaced shelf, put the bins back and it works perfectly again. No problem at all, took less that 15 min. including removing food items from shelf and putting shelf back into the refrigerator.
Parts Used:
Center Rail
  • Marie from Weeki Wachee, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Ice mold was leaking causing all the ice to freeze into one chunk.
Got the main bolts off and unplugged and removed the ice maker. Had to remove all parts and rebuild it on the new mold. Was more complex than I thought but was able to get it done. Note where everything was as you take it off and you'll do fine.
Parts Used:
Ice Mold
  • Douglas from Spring, TX
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
Installing the Ice and Water Filter
Take filter out of the box and open the refrigerator. Open the housing in the frig that holds the filter and twist the light-blue piece 1/4 turn, counter-clockwise. (Put the light-blue piece in a safe place.) Take foil away from filter. With 1/4 turn in the clockwise direction, twist the filter into its position. Let five gallons run through the system to get fresh, filtered water.
Parts Used:
Refrigerator Water Filter
  • Daniel from Chicago Heights, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken because parts are made of plastic
Pretty simple. Just lift out old parts and put new ones in
Parts Used:
Center Rail Shelf Trim - White
  • Gordon from Elgin, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broken bracket
Unscrewed the broken panel and replaced with the new one. Had to remove 3 drawers and shelves to gain access but found it real easy to replace the part.
Parts Used:
Pantry End Cap Kit, LH and RH Refrigerator Water Filter
  • Dolores from Bakersfield, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
broken fan blade
unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.
Parts Used:
Fan Blade
  • David from Ceres, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Broke parts due to grandchildren not being careful with middle drawer
to repair the center rail, all I did was remove the food and the top glass and insert the rail!!! to repair the end cap all I did was remove the big drawer and remove the broken end cap and replace with the new one. My only thought is this is the third end cap I have had to replace not very sturdy construction where the lid hangs
Parts Used:
Center Rail Pantry End Cap Kit, LH and RH
  • Vickie from London, KY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Broke the pin off the end cap for the pantry
Remove the vegetable and fruit drawers. Cover of the pantry was off due to the broken pin. Remove the three nuts with a nut driver. Lift up on the old end cap to remove and replace it with the new one. Replace the nuts and put the cover back on. Replace the two drawers and you are done. Repair was easy
Parts Used:
Pantry End Cap Kit, LH and RH
  • Mitchell from Algoma, WI
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Needed to replace the ice filter
Opened the refrigerator door, pulled down the filter cover, twisted the old one out and removed it. Placed the new one in - twisted it into place, replaced the cover and closed the door. It is working great!!
Parts Used:
Refrigerator Water Filter
  • Charlotte from Texarkana, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Broken lower drawer lid hinge
Removed drawers from fridge, removed screws/bolts from end cap, removed end cap with busted hinge pin,installed new end cap with lid , replaced drawers
Parts Used:
Pantry End Cap Kit, LH and RH
  • Chris from Amherst, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the AFI2538AEB
811 - 825 of 863
Back to Top