AFI2538AEB Refrigerator - Instructions

Removed lower drawer and two drawers above the section to get to the left side guide. Removed screws on old guide and installed new guide. Placed drawers and new cover back into the refrigerator. Done!

Found "pegs" either side of drawer found "holes on side of lid pushed holes on side of lid onto pegs.

Replaced the start relay in about 5 minutes and plugged the fridge in and it started working. Easy repair to get fridge working again.

Removed all plastic drawers and glass shelf. removed two screws holding the part to the side. Removed the slider metal part and placed it on the new part. Reversed the process, project complete.

The Deli Drawer needs to be re-engineered as it is constantly getting stuck when closing which caused pin to break. Fix: removed deli drawer and contents, removed 2 screws holding right-side metal slider and two more screws holding Pantry end cap. Surprise was that the Pantry End Cap had a long, movable plastic arm attached (used to adjust amount of cold air delivered to deli drawer). This long arm has to be carefully removed (unbelievable) from the pantry end cap in order to replace on new end cap. Luckily nothing broke. Count on 30-40 minutes. Sad that such a high-end refrig couldn't have a better design.

I cleared the bottom drawers and lifted out the glass and set aside. Removed both drawers. Removing right side panel (end cap) was just 2 screws for hinge and 2 screws for end cap. Note that there is a small tab toward front of end cap that needs to be gently popped out. Taking the temperature control lever and slide assemblies were easy once I figured out how they snapped out and back into place. No tools required but takes a little looking and thinking to swap them out. Try moving lever at an angle to facilitate replacement. Swap hinge and then position new end cap in place and screw in place with the two screws. Add drawers and glass back in. Ouila!

I unscrewed three screws and took off broken side. Then I unscrewed three screws and removed and replaced drawer slider. I then replaced old side with the new one.Thanks you for making this so easy.

I simply snapped it into place, removing the protective covering during the process. Although the cost of the part was higher than expected for a simple piece of clear molded plastic, the whole job took about two minutes total. And, moreover, the part arrived two days earlier than I anticipated.