RELAY-STRT W10920279

Hello Dan, thank you for your question. Every fridge compressor has a start relay and an overload. Sometimes they are made into one part or available separately. Your start relay is under the black square cover that is mounted to the side of the compressor. You can replace the start and overload as a combination by ordering PartSelect Number PS11740412 or the start device by itself, by ordering PartSelect Number: PS11770133. There is also an installation video that will show you how to access and replace the start device. That can be found by searching the pt number PS11770133. I hope this helps!

Hello Lac, Thank you for contacting us. I suggest checking the following parts: PS11757023 Capacitor, and PS993073 Compressor Start Device Kit. Have a great day!

Hello Randy, Thank you for the question. Please see the link below for a video. Hope this helps! https://www.youtube.com/watch?v=sWCVeKaNPKY

Hello Chris, thank you for your question. Unfortunately, we do not have the reading specs for this unit. But we do have instructions to test. Find the "s" and "m" plug-type terminals and the "L" slip-on terminal. Position the relay on the floor, counter or table so the "s" and "m" terminal are facing down. Insert the multi-tester with one probe on each of the "s" and "m" terminals. Set the tester to zero ohms. Turn over the relay and after a clicking sound the reading should change to "infinity" if the relay is functioning. Turn the unit over again and place one probe from the "s" terminal to the "L" terminal. The tester should read "zero" again and when the relay is turned over, there should be no change in the reading if the unit is working properly. If it isn't, you'll need to replace it. I hope this helps!

Hi John, thank you for your question. When you are having temperature problems in your fridge, there are a few parts that could cause the issue. You can use a multi meter to test most of the parts. Make sure you cut power to your appliance before doing any repairs or tests. First you should test your defrost thermostat. Place the thermostat in ice cold water for 2-3 minutes after removing it from your appliance. It should be reading 0 ohms to be working correctly. Another part to check would be your defrost heater. Remove it from the appliance. It should be reading anywhere between 0 - 50 ohms to be working. You could check your temperature sensor. To find the correct reading for this part you will have to refer to your tech sheet that comes with your appliance. You can usually find this tech sheet behind the bottom grille of your fridge on either the right or left side. These are the most common parts that cause this issue in your appliance. So it is suggested you check them first. I hope that helps. Good luck with your repair.

Hello Samantha, thank you for inquiring. In addition to the Capacitor, you will want to consider either the Thermostat, part number PS11739232, or the Bi-Metal Defrost Thermostat, part number PS11750673 for your refrigerator. Good luck with your repair!

Hello Wilford, thank you for your question. For your model you would use the WPW10189190 Relay and Overload Combination- our part number is listed as PS11749877. We hope this helps.

Hi Frederick, thank you for your question. Neither of those parts you have there are what is listed underneath your model number directly. You want to go by the information found underneath your model number because that is all the current and updated information directly from your manufacturer, and we can guarantee you that the part you are getting will be correct. The run capacitor on your compressor is discontinued however the start relay is still available. Good luck with your repair.

Hello Christian, Thank you for the question. You will need to check for continuity with a multi meter. Hope this helps!

Hello Dora, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11770133. Hope this helps!