24488W0 General Electric Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Finding a drip pan that fit so that pots could sit level.
Ordered the drip pan from ParSelect.com. Unplugged element and took out old pan. Placed new pan in and replaced element. For the first time in many years, the part fit.
Parts Used:
-
Ann B from Hueytown, AL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Right Front [surface burner terminal block kit]
We did the repair by following the inclosed instructions. we are elderly retired average ages 82. This was our first repair and it went very well. We are so pleased to have saved over $80.00 compared with hired labor 3 yre. ago for the same part. Thanks so much for your good service.
Parts Used:
-
Wayne from Montoursville, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Bottom heating element in electric stove was broken
1.)Turned off stove breaker in electric panel 2.)Moved stove and unplugged it 3.)At the back of the stove removed the clips from the bottom heating element 4.)Removed the stove door by opening it half way and pulling up, this makes it easier to reach inside 5.)Removed the heating element bolts 6.) go in reverse order to reassemble. Note: Took the time to give the stove a good cleaning.
Parts Used:
-
Paul D. from Walker, MI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Baking element burned into.
Removed two screws holding the element in place. Carefully pulled the element from stove, as not to pull wires off element. Removed wires and installed new element.
Parts Used:
-
Robert from Flowood, MS
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
Oven element burn in three pieces
It was not a repair, just a replacement of the element. Very easy and no challenges at all.
Parts Used:
-
Willard from St. Helens, OR
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
rht. front element would not heat properly
I read parts select instructions and i was done in less than 30 minutes. Since 1988, this is the 1st. part that I had to replace. I now have parts select on my favorites list.
Parts Used:
-
Rod from Huron, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Oven not heating although the broiler did heat.
Turn off range circuit breaker; remove and save nuts holding old element; disconnect old element from wires; connect new element to wires; tighten new element in using the nuts you have kept. Turn on the breaker, turn on your oven. WARNING: INSULATION SHOULD BE KEPT AWAY FROM CONNECTED WIRES, OTHERWISE IT BURNS WHEN OVEN IS TURNED ON AND YOU WILL HAVE TO UNDO THE NEW ELEMENT AND PUSH THE INSULATION OUT OF THE WAY AND THEN REDO THE NEW ELEMENT.
Parts Used:
-
Bobbie from University Place, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
element broke in 2 pieces
removed broken element and installed new element when received from UPS -very simple -
Parts Used:
-
Nancy from Louisa, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
element heat wouldn vary
slid the range away from wall. disconnect power. removed back,compared switches and marked wires.installed new switch and wires.the adapter for the control knob was a problem it left the knob out futher than original i had to modify the plastic adapter and got it close enought! the most time spent was cleaning up the floor before putting the range back.
Parts Used:
-
Leonard from Winter, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Plastic Roller on hinge broke in half
Following the repair video made the job very easy and quick, about a 5 minute repair. Wife says oven door never worked better. Thanks a lot for all your help.
Parts Used:
-
Dan from Granville, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
one oven hinge broken
It took longer to watch the video on how to replace the hinges than it did to replace them. Simple and easy. Video knocked it out of the park for ease. And now the oven door works great! thanks!!!! Video suggested if you're replacing one side do both, couldn't agree more.
Parts Used:
-
Bonnie from Tucson, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
broken roller on hinge
I unscrewed the broken hinge, removed the tension spring and replaced the old hinge with the new one. total time 5 mins works great.
Parts Used:
-
Frank from East Moriches, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!