Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
JESUS H - May 23, 2018
Verified Purchase
Not the correct part
There was nothing wrong with the part itself.except it did not fit. It was not a direct fit. I would have had to modify my engine shaft.
★★★★★
★★★★★
Justin H - May 2, 2018
Verified Purchase
Put in the right model number and got sent the wrong recoil????.
Part was in good condition, just wasn’t the correct part. Was trying to trying to find a recoil for a ryan jr sod cutter.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.3 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Gas tank leaking, pull starter rivets worn, rope and rope bushing worn
The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount. To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill sw
... Read moreitch wire Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jesus
May 7, 2018
Will this product fit mod. 283707 0136 01? It is on a Snapper srm130 rear engine 12hp.
For model number 283707 0136-01
Hello Jesus, thank you for your question. Yes, the Starter-Rewind 693900 is a compatible part for your model. Good luck with your repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Justin
April 17, 2018
Does this kit come already rewound and ready for use?
For model number 171432-0521-01
Hi Justin, Thank you for the question. Yes, the Starter-Rewind comes rewound and ready to use. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.