Average Repair Rating: 5.0 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Displayed “Door Loc” which was not correct error message
Replaced door latch after removing rubber seal from tub to access door latch. Simple replacement but did not correct issue. Notified service technician to determine error codes and had to replaced display panel and control module.
John from SHERIDAN, WY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Patricia
August 6, 2021
I recently broke the lock on my washer and the door will not close. Do i need to replace the inner part of the door or just the door latch?
For model number WFW5620HW0
Hello Patricia, Thank you for writing. We have researched the model you have provided and have found
the part you are looking for Washer Door Latch PartSelect Number PS12711558. You will only need to replace the Inner-Door PartSelect Number PS12711675 section of the door if it is broken as well. With the door opened, remove metal ring and spring holding gasket in place. Next, unscrew the latch to remove the Harness. Lastly, install the new latch and re assemble it. We hope this helps.
How to test if the door latch w11316250 is defective, can you use a multimeter to check for continuity. Latch clicks 4 or 5 times before you get the door latch error codes f5 e2 or e3. latch will lock but not show locked on the panel. Unlocks when you turn off and restart the washer but won't start the cycle. Flashes code again
For model number WFW5620HW0
Hello Mike, Thank you for the question. Use a Multimeter probe to touch one of the terminals and the other probe to touch the second terminal. Actuate the switch. If the meter reading shows zero ohms of resistance. The switch has continuity and is good. We hope this helps!
Was this helpful?
Thank you for voting!
David
January 21, 2023
Door lock inner plastic finger is broken, what replacement part is required and how do I replace it. Request was denied by Lowes, so I will need to do the work.
For model number MHW5630HC
Hello David. We are glad you asked! Yes, the Door Latch PS12711558 you had chosen is compatible with your model. With the door opened, remove metal ring and spring holding gasket in place. Next, unscrew the latch to remove the Harness. Lastly, install the new latch and re assemble it. We are pleased to have been able to help.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
