| |
25 of 28 people found this instruction helpful
Parts Used:
- Ice Cutter Grid Complete Assembly
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver
Customer: Brad from Bakersfield, CA
Grid assembly had a broken wire and would not separate the ice sheets into cubes
I removed the 2 screws on each side of the grid and disconnected the electrical plugs attached to the grid. I slid the broken unit out. I then carefully slid the new unit in making sure not to pinch any of the electrical wires. I replaced the mounting screws, plugged the 3 connectors back into place and turned the ice maker back on. I had ice cubes within a couple of hours
|
2 of 2 people found this instruction helpful
Parts Used:
- Ice Cutter Grid Complete Assembly
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Screw drivers
Customer: Tony from HOUSTON, TX
The wires in the cutter grid assembly were briken
Replaced the assy. But, I would have been happier if you sold just the wires. I could have replaced the wires at a much lower cost and may have taken less than an hour to replace the wires.Still happy - the ice maker works.
|
2 of 3 people found this instruction helpful
Parts Used:
- Ice Cutter Grid Complete Assembly
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver
Customer: John from NORMAN, OK
Broken ice cutter grid
Unplugged the unit. Removed 2 screws to remove front cover to access the cutter grid.removed 2 screws to the cutter grid, unsnapped power connector and removed broken grid. Slid new grid in place, reconnected power connector, replaced screws, plugged in ice maker and slid back in place. Very easy!!!
|
3 of 7 people found this instruction helpful
Parts Used:
- Ice Cutter Grid Complete Assembly
Level of Difficulty: Difficult
Time to do repair: More than 2 hours
Tools: Nutdriver
Customer: Thomas from Powell, OH
Cutter on ice maker failed and needed to be replaced
I completely broke down the unit cleaning or replacing any part with rust. The replacement grid assembly (cutter) came from partselect within days of ordering. I was able reassemble the unit with the new grid assemble. Now have fresh ice. Thanks Partselect... you made this do-it-your-selfer very HAPPY! My wife cannot beleive I got the unit back together.
|
2 of 12 people found this instruction helpful
Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Pliers, Screw drivers, Wrench set
Customer: Lawrence from Houston, TX
Replaced defective parts
had to have a strong box on the floor to support the double oven when removed. lot's of screws and wires to contend with.
|