YGH8155XMQ0 Whirlpool Microwave - Instructions

Unscrewed the remaining (2) screws that held the vent in place, placed the new grill in the tab loctators, and screwed it into place. Done...in less than 10 minutes. It took me 15 minutes to find my wife to show her what a nice job I did.

First remove two screws on top of microwave. Pull off old vent grill. Finally line up new vent grill (bottom edge first) then snap into place. Replace two screws on top of microwave.

This was a piece of cake! Less than 48 hours to get the part and 3 minutes to find and return the screwdriver and 3 to make the repair! I removed two screws, the old grill and then set the new grill in place and rescrewed the screws.

First, the screws were removed that held the vent grill to take off grill. The new vent grill was then replaced in a very short time. No problems at all.

I removed the 2 screws holding the broken vent grill, placed the new one in place and put the 2 screws back in place. Took less than 5 minutes from opening package to replacing the grill.

I removed the broken tabs with a screwdriver and snaped in the new cover replacing the screws once I had it in place. the entire job took less than 5 min.

First, I ordered the part.The part was sent to me within 2 days.Then,I removed the old one that was always falling off and mounted the new one. It was a perfect fit.

I have been doing repair on things on my own for years, I am a retired prevenative maintenace supervisor.
While cleaning the microwave vent grill from being old it fell apart, so I ordered the part using the internet to find the a company that has the same part, the part didnt take long before I recieved it. It didnt take five minutes to install it, and it saved me cash in the pocket from someone else to do the work. wallen

put the turntable in and had a Rum and Coke to celebrate. Your service was GREATTTTTT...

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall easy to install.

I remove the old broken Grill Vent by loosing two screws and just put the new one and adjusted with the same two screws.

I simply removed the original 2 screws for the old grill, attached the new grill, fastened it with the original screws & It fit perfectly in less than 5 minutes time.

Having the correct model number helps:
Just place the parts in the microwave and it worked.

Just remove the old one, inserted the new grill and tightened the screws on the top of the microwave.