WRT771RWYW01 Whirlpool Refrigerator - Instructions

After unplugging the microwave and removing the screw, I removed the old bulb and put in the new one!! I made sure it was in securely and the difference in the light was awesome! I use this light when I bake bread and let it rise inside the microwave, but DO NOT turn it on. The heat from this light helps the bread to rise properly!!

Replaced with new ice machine. Three screws to take out ice machine, took off water lines put new one in. Could not be easier.

Took the old one out and put the new one in.

Discovered that the fan in the freezer was not working properly. Removed the ice maker, paneling, wire harness and inserted new motor. Worked immediately and began circulating the cold air into the refrigerator.

No instructions with part. Found a picture on line and changed the arm, but it didn't fix the problem. Fairly easy after figured out what needed to be done to get to the part.

removed the old ice maker, removed the cable from the old as none of the ones included were correct, and attached it to the new. within in two hours it was making ice.

Repair went just like the video. Since refrigerator and freezer are side-by-side, it's a little harder to get to the screws. This is where the small mirror comes in handy.

I had to take the icemaker cover door off to get the icemaker in. Then I realized I needed to use the additional brackets.

Easy. Followed directions. Ice bucket is now full. I highly recommend this service (fast shipping) and instructional videos make it a cake walk.

All of the parts are removed and install through the front of the freezer bin. Remove three screws and unplug the old one. I plugged the old wiring directly in and set the new ice maker on two of the screws for alignment, then screwed in the third screw, tightened everything. Install the arm that checks the status of the amount of ice and waited for it to fill up with ice.

alone

Symptom: The ice maker was making ice, but sometimes the water would run and overflow at the entrance of the ice maker, spilling water into the ice catch and turning all of the ice into a huge block. The problem was that the liner of the ice maker had started to flake off, but only on part of the unit. When water would flow into the ice maker, the exposed part would freeze quickly, creating an ice dam and block the rest of the water from flowing into the other trays, thus overflowing. Solution: A new ice maker unit was ordered online, then after watching the video on how to fix, the process was straightforward and fairly simple. There is one screw to remove, 2 to loosen, and a wire harness to remove to remove the ice making unit. Then the ice full bar was removed from the old unit and put onto the new unit and the entire assembly replaced inside the freezer. The most difficult part of the job was loosening the screws by touch as there isn't a lot of room to see.

Unplugged, turned off water. Simply took out bottom screw, then two top screws. Disconnected writing harness. Put in the new reversing order. Then like new again!

Followed the video on Parts Select and it was a breeze.

Remove entire ice maker unit from freezer to test for function. Determined to be an electrical malfunction issue. Installed replacement ice maker unit. Easy fix, perfect fit replacement unit.