WJSR2070B2WW General Electric Washer - Instructions

Watch how to fix it on You Tube. Order the part I needed and fixed. Real simple. That is it.

My washer was overflowing when filling. Stopped filling when i unplugged from wall so i knew it was the pressure switch because the tube was fine. It took 28 hours from the time i placed the order to the time it hit my front porch. Got home from work and two minutes later i was washing clothes. Thanks for all the info, Tom

Took the front panel off and it looked like everything was OK with the transmission, etc. Pulled out the agitator and noticed that the coupler had stripped out splines. New coupler was a later design, but was backward compatible with the new bolt included. Spline slipped on with no problem and hold down bolt snugged down just fine. Snapped the agitator back on and was in business.

old dryer knob had lost its spring and would not turn on. simply pulled old knob off and replaced by pushing new knob onto shaft. voila! saved myself a service call.

remove top panel, replace the compression clip, then replace'd the top panel, w/pliers, remove'd then plastic clip from the timer knob, remove old knob, install new one, DONE! I've never had a place that had all parts in stock, and at my door with-in 2 days! UN-BELEIVABLE! THANKS

I removed the plastic pin, took the knob off, put the new one on, then replaced the plastic pin. EXTREMELY easy.

order part. replace

I watched the video you provided and I could't believe how simple it was. I'm 67 yrs old and I just followed the video instructions.

I pulled the top of the agitator off (the softener dispenser) then pulled the agitator itself off. I had to pull with some force. I used the socket wrench to remove the bolt on top of the agitator coupling. I then pulled off the old agitator coupling, replaced it with the new part. Used the socket wrench to tighten the new bolt. Lined up the slots on the new coupling with the agitator top, it slid on with a little resistance. The last part to replace was the softener dispencer.

Use a flat head screw drive to push the clip off the timer stem which holds the knob, which is behind the knob, pulled old knob off, place new knob on timer stem, used needle nose pliers to push new clip on timer stem to hold knob on

Just push the new knob over the metal pin

I used the piler to take off the old knob then install the new one.

Gently turned washer over onto its front. Removed bottom metal panel (3 or 4 screws on each side). Removed old belt. Installed new belt. NOTE: The new belt is a tight and perfect fit, therefore it will not want fit on to both pulleys/ rotating discs. I have found the best method is to start the belt on the disc that drives the belt. Then place as much of the belt over the disc that sits below the washing machine drum as is possible(the spinning part)and then turn the belt by hand and the belt should pop on to the disc. If the belt goes on easily you may have the wrong belt as the belt must be tight to achieve the traction necessary for the washing machine to spin. HOPE THIS HELPS!! A screwdriver may be handy in helping to pry on the belt. Good look.

I went on Utube and watched a video. Explains exactly what you have to do. A real skinny pair of electrical pliers helps to get the plastic pin out. The replacement knob comes with a new pin. This repair actually does take less than 15 minutes.

I removed the clip with needle nose pliers pulled the knob off,put the new knob on and replaced the clip.