WCSR4170D5WW General Electric Washer - Instructions

took 4 screws off top of control panel, lifted it out, pulled off control knob, removed 2 electric wires ( unit was UNPLUGED )lifted up / pried up metal tab, turned counterclockwise 1/4 turn , removed plastic hose and walla ! reversed to installed. a piece of cake, less than a two beer job ! p.s, you tube has video's of this and helped alot. very very easy. now i'am taking down my kenmore elete he3t washer ( made in MEXICO of course ) for outer tub bearings. everything has to come out but i can do it ! woot woot !! and a special thanks to PartSelect for having the correct part.

old dryer knob had lost its spring and would not turn on. simply pulled old knob off and replaced by pushing new knob onto shaft. voila! saved myself a service call.

We couldn't get a repair to come out - were told to buy a new because it would cost too much to fix. I did not agree. I pulled the agitator off and discovered it was not working and the agitator coupler was spinning. I ordered both and put them in myself. My washer now worked like new! All for less than $100. The service guy wouldn't eve come out for less than $175 and that did not include parts!

I watched the video on the knob and clip, ordered the new knob only to find out I needed a new timer as well. The little gears were striped off at a closer look. So I ordered a new timer. They were sent out right away, that was nice. We both parts now, the install took about ten minutes.

Ordering the new knob was very easy.

I just popped in the new agitator. The coupler wasn't needed but I will keep it just in case.

I removed the agitator, replaced the agitator coupling. The guy at the appliance store where I was able to find the part said to check the splines on the inside of the agitator as well. Glad I did, the splines on the agitator were worn out too. So by checking both, if and when the problem occurs, REPLACE BOTH parts! This will save a lot of grief for you!

Was very easy to remove and replace. The instructional video let me know what to expect

Unit unplugged. Next day delivery, saved plastic clip and two screws from hose connect to washer , removed leaking hose ,replaced with new hose fully pushed into unit with plastic clip already in place on new hose. Tightened screws on plastic holding clip on new hose. Done complete job in 5 minutes.

Used pliers to remove old clip. Installed new clip and knob. Very easy.

Lay the washer on its side, unscrew three screw to loose the rotor, put the belt and screw the rotor back.

replaced cycle selector knob. received part in less than 24 hrs.

Replaced the knob by removing the old one an installing the new one with plastic clip. Very easy repair. The water pumb was not working. After determining that it was getting electricity, I removed it and took it apart to determine whether or not it was clogged. To my amazement,I found a "quarter" stuck at the bottom. With a little effort, I removed the piece and put the pump back together, reinstalled it to the hoses and the repair was complete. The Part Select site is fantastic. The schmatic drawings and diagosntic information make even very complex repairs possible! Thank you. I am a very happy customer!

I used needle-nose pliers to pry out the little c-clamp that held on the timer knob, then easily pulled off the knob. I used the vacuum cleaner to clear the broken plastic teeth from area surrounding the stem. Then I simply pushed on the new knob. Whole job took about 5 minutes.

recieved part in 3 days put knob in and was ready to go, good as new thanks