HTS15BBMBRWW Hotpoint Refrigerator - Instructions

It was easy amd it looks awesome. Thanks.

First thing I did was un-plug the fan motor located in the freezer compartment and test it for voltage, which it had, telling me the fan motor was shot.I ordered the parts, they arrived in short order and the fan motor was replaced. It took little time and there were no levers, pulleys,servos, gobs of wiring or stacks of gears in a maze of bearings to deal with. Unplug the unit, remove the food rack, ice cube maker(just loosen the 2 screws and lift up)remove the air channel in the center as well as the back panel. Unplug the fan motor and remove the screws securing the motor bracket and lift out. Very simple.

I was so happy to find the new part went right in and fit great! I was worried because the part number changed like 3x from original part number. It also has a different design, but fit perfect! I also am glad that I found this company on Internet because price was lower than other stores that I usually by G.E. parts from. Very happy!

I was amazed at the fast shipment. Recieved the part in 3 days. Removed old shelf and installed new one. Fit perfect!Thanks to Parts Select !

The freezer and food door gaskets were easy to install, I put 6" of hot water in the bathtub and left the gaskets in the water for 5 minutes before installing into the door tracks. The drawer cover lays on top of the rests on the sides and the back of the lower compartment.

I took off the broken end caps and hooked the new end caps to the new bars and pushed them into the slots where they were suppose to go. and they snapped right in. Perfect size and everything. Thanks

it was so easy to replace the part and good experience I love when I can trouble shoot and fix the problem

Removed Veg Drawers and old cover. Installed new cover and replace drawers after cleaning. No tools needed and did not have to use spacers, though I did save them.

Replaced vegetable drawer cover with new one

put the missing peices back on very simple

Took the old cover out and put new one in no tools needed.

I started at the compressor and replaced the overload and the Ptcr first and that did not make the compressor start running again, so I replaced the capasitor and it still did not start, so I bit the bulett and replaced the Main Control Board and that is what I should have checked first, when I removed the old one I found a little burnt spot on the back that I could not see from the front. The new one did not look exactly like the old one, it had two more wire terminals than the old one, but just leave them blank and everything will work just fine!

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

I simply followed the online video instructions.made the job easy and fun.

after simply replacing shelf, I used the enclosed plactic washers to raise the height of door, so it would clear new shelf. It all worked as planned, thanks