HDA110S-55AW Hotpoint Dishwasher - Instructions

Followed the instructions on the website video. Piece of cake! No tools were required. Insert the plastic insert into the wheel ensuring the right side faces the rack. Snap onto the rack once done.

Installed new ones as per instruction

I ordered the corner baffles and installed them in the corners in just minutes. Repair company quoted me about $100 if they had the parts on the truck. If they had to come back it would be another service call. Did the repairs my self for $24 with shipping charges. Happy Customer

Simply replaced both cables to allow door to open and operate as intended, without dropping unrestrained, which could possibly cause more serious damage to door and/or washer.

follow your video instruction. very simple.

When I first noticed my unit leaking I noted that the leak was dripping right in the middle. So, I went straight to this web site with my model number and the 1st part I saw was for a Gasket Insert which is a small piece that completes the sea. I received that part in 2 day and did the repair and I still had leakage. I went back on the web site and looked further and came across info for the Corner Tub Baffles. I did not even know there were there. I removed mine and it was very obvious that the original Baffles were very worn and wrapped. In addition, the unit was quite filthy. I ordered the two replacement baffles. The parts arrived in two days, did the minor repair and now I have no leaks.

The PartSelect video told me to take the end caps of the track and simply snap the old wheels off. It was easy. I popped the new wheels on, put the rack back on, and reattached the end caps. I was surprised by how simple it was to repair a major kitchen appliance.

order new gasket and it took us last them 15 min. and it was ready. I will start using it at least twice a month from now on. I would like to thank Part Select for getting the part that we need so fast and with helpful instructionf

Pieces just snapped together. Simple an quick. Part select was wonderful in assisting.

Watched the on-line video. It was great and made the replacement job easy. Without the video, I probably would have broken the plastic end caps while trying to take them off. I highly recommend watching any available repair videos.

Original part no longer made. Substitute too small by a half an inch. Corrected the problem by removing the 4 corner wheels from the old rack and put them on the new one. Now, it fits and works perfectly.

I didn't see any obvious defects in the washer like a plugged drain or obstruction in the pump intake, so I decided to try a new lower spray tower. I loosened the tower with a large pair of channelocks (arc joint pliers) by grabbing it near the base. The unit unscrews in the normal manner, i.e. counterclockwise. Once it's loose, it can be removed by hand. Thread in the new tower and snug it down. Done. Cleaning problem solved.

I followed the video instructions..I was concerned that the end pieces would be a problem, so I purchased replacements also, but they came off with no problem - thanks to the video.They only cost about $2.50, so I will keep them in stock in case I need them at a later date.Without the video, it probably would have driven me nuts trying to figure out how to remove the end pieces, but when you see it done, it was simple.....Thanks Loads.

Remove lower covers (2) Remove broken cable. Replace with two new ones. Hook eyelet end to one side then springs then hook other eyelet to other side pull springs tight and hook to cable. Keep both sides tight doing so.