Corner Tub Baffle - Lower Right WD8X227

I used Partselect.com website to educate myself on parts needed for my model of dishwasher. Also reviewed repair instructions by others on the website and learned repair and replacement was straight forward and simple. I ordered parts from Partselect.com, they came promptly, and were the correct parts. Based on the repair instructions, I removed the fascia panel at the bottom of my dishwasher to expose the cable and spring setup for my model dishwasher, cleaned the area and installed the new parts - it took only a few minutes - then I replaced the panel and secured it with the sheet metal screws that were holding it in place. I opened the dishwasher door. My wife had already cleaned the corners of the tub where the old baffles had been, so I pressed the new baffles into place with my fingers - no tools were required for baffle installation. Dishwasher is back in service; thanks to the information, parts and prompt service provided by Partselect.com ! My wife is pleased and so am I.

researched the problem, listened to you tube, ordered the parts
and did the repair. Very easy to do, only took a few minutes.

replaced all parts with screwdriver and my hands
cleaned all surfaces before installing and had to be sure the door gasket fit under the gasket insert,& repositioned door gasket twice till I got it right.
videos were very good except the positioning of door gasket to gasket insert should be shown -- critical flaw!

Replaced door seal and corner seals. Be sure to heat door seal in dryer be for instillation, 2 minutes. Makes for an easy installation.

since they weren't that expensive, I chose to order all 4 gasket parts - the left and right corners, the long gasket, and the small center gasket insert (5" long). For $100 I decided it would either work or not -- at 15+ years old, I could really have gotten a new dishwasher. As it turns out, all of the plastic parts were getting hard and brittle and caked with detergent -- and so replacing them ALL was the right choice. they all work together. The corner pieces snapped into place and the gasket had a flexible barbed edge that I fit into place in a channel. I didn't have to take the door off or use any tools. It was a little hard to do since it was upside down and you couldn't see, but better than taking the door off. The new gaskets are soft and pliable and there were no more leaks!

Removed the corner baffles by lifting up and out. Cleaned the area and pushed new replacements in position.

Removed door seal by pulling on the end.
Press new seal in to the slot. Work in to slot a tree ound door.

do not know where to position the detergent door arm when reinstalling the inner door. cannot get the detergent door to function. tried several positions. HELP. I do not have the mechanical timer switch, its electronic finger touch.

Change Drain solenoid.

Replaced the lower right and lower left corner tub baffles

I simply lifted the baffles out and cleaned the base and installed the new baffles and started the dishwasher and NO LEAKS.