Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Broken plate
Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.
You had alerted that it was imperative to unplug unit before starting to remove defective bulb. As described, there was silicon on bulb and socket and bulb broke upon my attempt to remove. Had to use needle nose pliers to get metal base of old bulb from socket, then all went well.
I had no problem installing the new filter. Just used a phillips screw driver to remove the two screws holding the vent cover in place. Cleaned the dust out of the ducts and reinstalled the new filter. The screws must be held to the screw driver with your finger tips so you don't drop them in the vent cover. The most difficulty I had was in clearing the clean code from the screen. There are no instructions in the owners manual for doing this. But after several tries I got it.
I unscrewed the filter cover, replaced the charcoal filter and replace the cover. The other wire mesh filter slides right into place. You sent me the right parts for my filter replacement on my microwave. Easy install. Thanks
grill vent broken off at plastic attachment points
Poorly designed plastic grill vent covered by stainless steel held by 2 metal screws broke off with minimal pressure during routine cleaning. Easily replaced in 2 minutes with Phillips screwdriver. Partselect very helpful in ordering process. Would not hesitate to use them again. Fairly priced, knowledgeable and sympathetic help. Received part in 3 days from order. Awesome service.
To replace charcoal filter in microwave, had to take grill off. Tabs on 2 of the 3 screws were fractured and then glued. This happened at the factory. Found Parts Select on the internet who had the grill and filter. Received parts in less than 5 days. Grill was easy to install as the 3rd tab had been eliminated on the replacement part. THANKS PARTS SELECT
The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.
The lady in the Nova Scotia call center should get all the credit for being able to identify the part I needed from only the very limited information I was able to give her. Employee of the month for her. She also had such a great can do attitude. Lawence Baier
in 2 yrs the charcoal filter had NEVER been changed and it was smelling horrible--so had to be done !
--simpley removed 2 screws, removed old filter--but had PLENTY of cleaning to do before putting in the new filter !My husband LOVES to cook and pan fry foods--it won't go that long before being replaced in the future!