G32026PEKW Maytag Refrigerator - Instructions

removed bins and meat/cheese cover. Removed slider with two screws. Removed broken end cap with two screws. There is a plastic linkage to a vent in the rear. Removed three pieces from inside the end cap. These are are all snap-in parts, but require manipulation. Took some time to figure out. Same on reinstall. Cleaned up drawers and cover. Easy!

We tried repairing with a new switch which was very easy to install but it didn't fix the problem.

Took out the old and slipped the new

Replaced valve on back of freezer and replaced the ice maker tray. Took about 20 minutes and had new ice cubes 1/2 hour later. It's working like it did when it was new

Replaced part--4 hexhead screws. This is my third time changing this part (right and left) and was happy to see that an obviously under-engineered design has been modified. The pin bracket has been reinforced and appears much stronger.The most time consuming portion of the fix was cleaning off the shelves for removal. Thanks for asking. Norm Notdurft

This is an easy fix, simply remove and replace. What I was impressed with is that a how to video was provided along with my part. I wish all manufactures would offer this, the video was easy to understand and you had a good view of the operation. Thanks, a job well done.

I watched the on line you tube video on how to DIY. The putty knife worked to pop out the switch. I used the standar screwdriver to unplug the switch from the wire harness. Then plug in the new switch and pop it back in to the roof of the freezer. Tip: watch out when ordering the new switch - the freezer switch is different than the refrigerator switch. The freezer has three prongs. The fridge has two. I initially ordered the wrong part and added a week to the repair time and had to pay shipping to return the first switch.

took off the ice maker, unscrewed the body, replace icemaker shut-off arm, water fill cup & bearing, reconnected the unit & have ice now, Thank you PartSelect

I watched your "silent video". I am a 62 year old woman that is very hands on when it comes to tools and power tools. It was very easy.

I'm uoset that I sat and looked at the broken piece for a month wondering"what the heck is this going to cost me" The more you spend on the appliance the more they break. The repair was too easy. Remove the 2 drawers, remove the bottom draw and there are 3 nuts you need to back off. The whole piece comes off really easy. I left the drawer glide on and took it off after the whole piece was out. Attach the glide to new piece put it in place and screw it back together. Now gow wash the drawers and glass that you have been putting off and reinstall them. Start to finish 10 minutes,.