E23CS78EPS0 Electrolux Refrigerator - Instructions

I removed the door (2 minutes) by removing the door hinge cover (one cross-tip screw) and then loosened the tuo hinge mounting bolts. I then removed the broken bearing hinge and plate (3 minutes) from the bottom of the door and installed the bearing and plate, and then re-installed the door (2 minutes). My four-year-old helped me.

The part arrived in about 2 days! The right side support that is attached to the inside wall of the refridgerator, that holds the crisper guide, broke apart and would not support the crisper. We took everything off of that shelf and took out the crisper and the glass that is on the shelf. We then carefully pried the support from the interior wall (it was a slow tedious move to be sure we did not damage the wall of the fridge). We made sure all of the pieces were out and snapped the new one into place. For some reason the old one did not want to come out. It broke into many pieces and we carefully pulled all of the little pieces out of the notches

Called "local" repair warehouse and ordered part. They shipped the wrong part. Went on-line to Part Select and got the right part.

Remove screws under tray and trim piece. Lift up and remove face plate. Disconnect flat bundled wires and tape off. Remove ground wires. Remove face plate. Remove dispenser assembly. Remove and replace actuator. Reassemble.

repaced ice/water filtration (by pass ) hopeing it would fix problem . was not sucessful !

I watched the video and followed every step as outlined. It worked perfect, until I reconnected the supply line to my triple water valve. I used the old compression fitting and the compression nut. I should have cut the line and installed a new fitting and nut. The water on the floor the next morning reminded me of that. So back out I went and replaced the compression fitting and it has been as good as new. The ice maker took a few cycles to work again, I think it needed to fill the line with water first. But I have a huge sense of pride every time I hear water dispenced or ice dump in the freezer. Thanks for the help and encouragement!

DID IT JUST LIKE THE VIDEO SHOWED. UNHOOKED ELECTRICS, CUT TUBING, HOOKED UP ELECTRICS THEN TUBES TO NEW PART. PIECE OF CAKE.

Very simple less then five minutes.

replaced the lower cam on door. removed upper hinge lifted off door and pulled out old cam and replaced it.

it took longer to remove the food and all from the door than the repair. It was a very simple repair. two bolts to take the top hinge off, pulled the door off and set on counter, removed old, broken glide, slid new one in. I ordered both sides, but the closer plate was in great condition, so I didn't use it. put the door on, then the top hinge and now it shuts like new. total time to fix (minus taking the food out of the door and putting it back in) was about 10 minutes.

love this super easy remove two screws and replace thank you

The noise was made due to a loose part. I took the refrigerator door off and replaced the closer plate and hinge bearing. This solved the problem.

We took the door off the hinge which invovled removing the top screws on the door. The part that broke split in two pieces leaving the shank inside the bottom of the door hinge. The most challenging part of the repair was pulling that piece back out since there was very little to grab on to. Once we got that out it was easy to replace with the new piece.

This was an easy repair. I had already read about the same problem from another of your customers and followed his directions. But more remarkable than the ease of the repair was how quickly I received the part. I ordered the part, using standard delivery, at approximately 2:00 on Thursday afternoon and received it the next morning and had the refrigerator repaired within 24 hours of ordering the part. That's service.. Thanks

Replaced shelf