Models > 9119344190 > Instructions

9119344190 Kenmore Range - Instructions

All Instructions for the 9119344190
331 - 335 of 335
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
drawer coming out of the track and falling to the floor.
pulled drawer out and installed drawer guide
Parts Used:
Rear Drawer Glide
  • Steven from Waukesha, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Clips needed to re attach heating element
Pulled out old with pliers. Twisted new clips in per instructions.
Parts Used:
Single Heating Element Support Clip
  • Dennis from Orlando, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
Broken element
Remove the oven door, took racks out, and removed screws, disconnected wires and removed element. Reverse order, replaced element and put door back on.
Parts Used:
Bake Element
  • Harry from Sumter, SC
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Oven element caught on fire & needed to be replaces
I was able to follow the instructions here on line, but not being a repairman, I did not know how to unattach the wires from the element & reattach them. It appeared to me that I needed to unbend the wire clip to remove the wires, but I couldn't see how to do that. A friend came over and showed me they just slip off and on - very easy. Had I known that, he would not have had to drive over to my house!
Parts Used:
Bake Element
  • Fran from Tulsa, OK
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Old bake element burned out.
The repair was quite simple. After removing the oven racks and disconnecting power the old element came out with the removal of two bolts. My only issue was one of the power leads popped off and pulled back through the oven wall. Taking off the heat shield on the back of the oven let me push it right back through. Hookup and reassembly took less than five minutes.
Parts Used:
Bake Element
  • Richard C from Spring Hill, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 9119344190
331 - 335 of 335
Back to Top