5KRFX9000M00 KitchenAid Refrigerator - Instructions

20 seconds. Easy Easy.

I'm uoset that I sat and looked at the broken piece for a month wondering"what the heck is this going to cost me" The more you spend on the appliance the more they break. The repair was too easy. Remove the 2 drawers, remove the bottom draw and there are 3 nuts you need to back off. The whole piece comes off really easy. I left the drawer glide on and took it off after the whole piece was out. Attach the glide to new piece put it in place and screw it back together. Now gow wash the drawers and glass that you have been putting off and reinstall them. Start to finish 10 minutes,.

Opened up the compartment where the old filter was located, twisted it to take it out (be careful not to spill water in the filter!), and installed the new one. Even a 64 year old woman had no trouble!

Removed the left hing side and replaced it

replaced electric control board, defrost for six hours. next day (24 hours) same problem, dusterhoff2928@charter.net

Simply stick a putty knife between the switch and refrig wall. Pop out old swith, remove both wires by pulling off switch by terminals. Throw switch out. Put wires on new switch and push into slot and all done. Nothing to it! Took me 5 minutes if th

I removed all the neccesary shelves and drawers to get to the end cap, installed the replacement end cap and put the shelves, etc. back-finito!

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

I tried to remove the old light switch using a putty knife and a hammer. It was hard to compress the plastic tabs to pull it back through the hole, but all of a sudden, the lights came on. I guess banging on the switch freed-up the contacts. The new switch is now a spare part in case I need it.

Just replaced a water/ice filter..

After receiving the new part almost immediately,using two screw drivers, removed the broken switch from the plastic frame. Be careful not to scratch or otherwise tear the plastic...very pliable. Since the original switch was factory installed and the wires were packed in fiberglass insulation, the switch came out but the wires and clips were still in place and could not reach the new switch. It was necessary to pull them down with bent long nose pliers...used a lot of "pull" but the wires held up.Connected the switch, turned the power on and there was light! Reports from other users really took the uncertainty out of the task.

Simple! Pop the case open. Counterclockwise to remove old filter. Wipe out excess water. Unwrap new filter; remove tab. Place in filter holder; turn clockwise. Close case. Run water to remove air. Couldn't have been easier!

Was a snap. Took out the draws. Removed glass plate. Unscrewed endcap using socket set. Removed rail. Screwed rail to new endcap. Screwed in encap. Replaced all draws and plates. Didn't take more than ten minutes.

No instructions with part. Found a picture on line and changed the arm, but it didn't fix the problem. Fairly easy after figured out what needed to be done to get to the part.

remove the screw on the right side (about 3). remove the screws holding onto the slider. disconnect the right side panel and bring the panel all the way forward so that the part connected to the rear of the refrigerator comes loose. replace new panel and put parts back together in reverse.