Admiral Dryer Wire Plugs and Connectors

Videos!

Your Price

$10.79

Heating Element Connection Wire Kit

★★★★★

3 Reviews

PartSelect Number PS334206

Manufacturer Part Number 279457

This kit is used for electric clothes dryers, and it comes with a yellow wire nut.

Installation Instructions

Christopher from dublin, OH

no heat

took a couple differant parts to fix the dryer. i ordered one part at a time. i was expecting to wait the 5 days for shipping but i got home from work the next day of odering parts and they were there waiting for me on my doorstep. all three times i ordered. this website is the best site to order parts. i wont go to another website or store if i need to order parts for appliances. u guys have my business for life. thumbs up. Read more...

Your Price

$18.45

Terminal Block - Block Only

★★★★★

1 Review

PartSelect Number PS11741489

Manufacturer Part Number WP3397659

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

Installation Instructions

DAVID from LEESBURG, FL

One of the power cord connections on the terminal block was loose. Screw on terminal block was cross threaded when installed. Took six years to smoke the wire.

Removed and replaced terminal block, power cord and black wire to timer. Read more...

Your Price

$63.83

Terminal and Wire Kit

PartSelect Number PS334181

Manufacturer Part Number 279318

Your Price

$10.79

Terminal Block

PartSelect Number PS11743293

Manufacturer Part Number WP61923

This part is connected to the rear bulkhead of the dryer with screws. It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).

Installation Instructions

Henry from LA FOLLETTE, TN

Dryer not heating

Terminal Block was cracked and dryer was not receiving enough voltage, causing the heating element not to heat. Here were the steps I took to fix the problem:
1. Turn off breaker to dryer from 240v outlet
2. Unplug dryer from 240v wall outlet.
3. On outside, rear of dryer, remove cover plate and the clamp that the power cord goes through with nut driver or phillips screwdriver and take picture or write down how the power cord wires go to the terminal block.
4. Use nut driver or phillips screwdriver to remove the power cord wires from terminal block and ground wire from dryer body.
5. On top front of dryer, use large slotted screwdriver or some other tool to push in on the two clips in order to lift the cover up on dryer.
6. Take picture or write down how wires are attached to terminal block.
7. Remove wires from terminal block with nut driver or phillips screwdriver.
8. Use nut driver to remove terminal block from washer and install the new terminal block.
9. Reinstall wires to new terminal block.
10. Close dryer cover.
11. Reinstall clamp onto power cord wires and reinstall wires to new terminal block and ground wire to washer body then put cover plate back on.
12. Plug in dryer then turn on breaker.
13. Start dryer to see if it heats now. Read more...