Handle/Front WR12X10625

New parts just snapped in place. Perfect fit.

Emptyed shelf of food. Aligned new plastic front piece. Pressed front. Went right into place.

Just snapped the part in place. No tools needed

Really easy to install - they both snapped into place.

just snapped it on.. no problem

With an allen wrench, I removed the remaining and broken drawer slide brack assembly on the bottom of the refridgerators right side. I then installed the new right-handed drawer slide bracket assembly in a similar fashion. The freezer handle easily snapped into place. The entire process was completed within ten (10) minutes.

simply snap it on to the drawer. Very easy

Removed the cover plate. Noted which wires went were. Removed the wire leads and placed them on the new board. Replaced the board into the socket and restored power.

Handle just snaps on.

First, I removed the four screws holding the auger motor and solenoid in place. After testing the solenoid as good I replaced it and did more research. I was having several symptoms so was unsure which part or parts were bad. I spent $50 on a service call and got the diagnosis of a bad main board. I ordered the part and got it two days later. After removing the several screws from the rear panel it was so easy to remove and replace the board. Plugged it back in and it worked perfectly.