Average Repair Rating: 2.3 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
The inner burner of the triple burner assembly did not function
The logical first choice for replacement was the triple burner assembly since that is subject to failure for obvious reasons. It turned out that the burner assembly was fine by visual inspection and by virtue of a continuity measurement.
The second choice seemed to be the frame relay board and that turned out to be correct. T
... Read morehis was an educated guess since it is the "next" component going backwards, it is responsible for distributing the burner voltages, and that relays can have a reasonably high failure rate. This board could be tested but without schematics that seemed like a lot of effort, so I ordered it on a best guess.
Replacement of the board is not too difficult but does require some attention to detail, and patience is required to be sure that all the wires end up in the right place. Needle nose pliers are really helpful here. Take photographs, make a sketch, and label some of the obscure wires with painter's tape. Took about an hour or so.
Read less
Robert from TITUSVILLE, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Terry Black
January 20, 2022
Does the Frame Board WB27T11357 control the cook top burners? We have two burners on opposite corners that quit working at exactly the same time so I don't think it is the burner itself. There is also another board WB27T11299 are there 2 boards to control the burners and if yes which one does which burners, currently front left and right rear are not working.
Thanks
For model number PS950SFSS
Hello Terry, Thank you for your inquiry. The Frame board is the oven relay control board, which receives signals from the main oven control board and operates relays to regulate the top elements and elements inside the oven. Check both this board and the user interface board, part# PS8767155 for any visible damage or burn marks. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Chris
March 21, 2024
All of my cook top burners quit working all at the same time. The boars WB27T11357 controls those correct? So that would be the logical thing that is bad? When I cut each burner on with the controls the light comes on saying it’s on but the burner never heats up.
For model number PS978ST1SS
Hello Chris, thank you for reaching out. The control board, part number PS8754538, you mentioned controls the functions of the unit. We would recommend checking it and replace if it is faulty. We hope that helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
