Handle Support - White

Hi Darrin, Thank you for your inquiry. In order to remove the door lining so you can gain access to the screws holding the door handle in place, you will need to use a putty knife. Start at one side along the inside of the lining around the window edge and gently put the putty knife between the door lining and the door to release the tabs holding it place. The side where the door is hinged, you will need to pry the lining lose from the back side. Once this is complete you can remove the inner lining. With the lining removed you should see the screws holding the door in place. Sometimes the door handle may be held with 4 screws and you may not see the other 2 screws. If you remove the 2 screws and the handle does not come off you will need to remove the inner door frame with a putty knife using the same procedure as with the door lining so you can release the other screws. I hope this helps. Thank you and have a great day!

Hello Kim, Thank you for your inquiry. This part number is the supports which the handle attaches to on the door, you would need two. Part# PS8754173 is the handle itself, and part# PS8753375 is the screws which attach the handle to the supports and door. Hope this helps!

Hi Christine, Thank you for your question. This part is sold individually. You will need to order 2 of them. I hope this helps. Thank you and have a great day!

Hello Kevin, Thank you for the question. According to the description. This part is sold individually. Hope this helps!

Hello Bill, thank you for your question. The inner door frame has a seam around it where it snaps into the door. Using a putty knife slowly go around the inner door panel frame to release the tabs that hold it into place. The inner frame will pull away from the door and the screws for the handle will be accessible. I hope this helps!

Hello Bob, Thank you for the question. The support Part #: PS8753758 is sold separate from the handle Part #: PS8754174. Hope this helps!

Hi Brian, Thank you for the question. The Handle Supports are sold individually. Good luck with the repair!

Hello Tim, Thanks for your question. We would actually advise having a licensed technician install this part, as the microwave door contains shielding components that must be tested for any leaks in the microwave shield prior to safely using the microwave. That said, the door and door panel would just snap together. I hope this helps.

Hello Kevin, Thank you for the question. This part is white in color and is sold individually.Hope this helps!

Hi Bill, Thank you for your inquiry. This is the correct part for your appliance. I believe that there will be screws that are holding that inner bracket in. I hope that helps. Good luck with your repair.