Microwave Door Handle Support

Hi Robert, Thank you for your inquiry. This part is black. It is sold individually so you would need to order two. You should not need to replace your bolts unless they are broken. I hope this helps!

Hi Bob, Thank you for your question. You will have to use a thin tool, like putty knife or a butter knife, and gently pry off the back choke cover from the front frame of your door. There are tabs all along the perimeter that hold the whole door together. You gently pop them away so that you can take the pieces away from each other. That should reveal your screws. If not, then you just remove the choke in the same way and you should see the screws that hold the handle. Good luck with your repair.

Hi Doug, Thank you for your question. According to your model information and the manufacturer your top and bottom supports are actually the same part. These parts are sold individually so if you only need one then you would only need to purchase one. I hope that helps. Good luck with your repair.

Hello Tarrah, thank you for your question. If the broken spot is just where the screw connects into, at the very end of the handle you should only have to purchase the handle support, part number WB06X10939. Good luck with your repair!

Hi Tim, Thank you for your question. The part number listed under your model number for the microwave door handle is PS8754172. We hope this helps. Thank you and have a great day.

Hi Heather, there are 2 screws in total to unscrew. You will need to remove both to replace the handle. Thank you for your question and good luck with your repair!

Hello Constance, thank you for your question. If only one is broken, you would only have to replace one and they are sold individually. I hope this helps!

Hello Tom, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS8753755 and is a guarantee fit for this model. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Mana, Thank you for the question. Before you begin any repair please unplug the appliance from the electrical outlet. You will need to remove the plastic lining around the inside of the door. There are retainer clips holding the liner in place and you will need to use a putty knife to remove it. Depending on the type of microwave you have, you may have to come in from the bottom or from the top to remove the lining. Gently slide the putty knife in between the lining and the frame and go around the frame and gently pry it loose. On the hinge side you will need to come in from the backside to pry the lining off. If after you remove the lining you only see 2 screws, unthread them to see if the handle will come off. If it does not come off, you will have to remove the inside door panel in the same way you removed the lining. Once removed, unthread the remaining 2 screws and remove the old handle. Install the new door handle and reinstall both the inner door panel and the lining. Restore power to the microwave and everything should now work for you. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!