Halogen Lamp - 50W WB08X10057

Hi Earl, Thank you for your inquiry. Where the manufacturer has replaced the 40 watt bulb with a 50 watt bulb it should be safe to use. I hope this helps. Thank you and have a great day!

Hello Ryan, Thank you for the question. Yes, this is a 2 way bulb. Hope this helps!

Hi Jan, Thank you for your question. Yes, this would the correct light bulb for under the microwave. I hope this helps. Thank you and have a great day!

Hi Mike, Thank you for the question.This appliance only has the Halogen Bulbs. Hope this helps!

Hi Howard, Thank you for your question. The part number for the bulb you are looking for is PS2351821. For information on how to install the bulb, there is a video listed with part on our website that you may reference. When you bring the part up on our website, you will find the video just below the photo of the part. I hope this helps. Thank you and have a great day!

Hello Mark, thank you for your question. To install the inner light bulb you will want to first unplug the microwave. Then remove the vent grille or cover and any filters that are behind the vent (if applicable). When the vent is removed the lamp compartment cover should be visible. The cover can be removed by taking out the screw that holds the cover in place. If the cover is too difficult to access, you may need to remove the unit from the cabinet, or contact a service tech. Remove the bulb by pushing inward and turning counter-clockwise. Be very gentle. Replace the old bulb, then replace the compartment cover and grille. Plug in the microwave. I hope this helps!

Hi Pat, Thank you for your question. Your appliance recommends that you use a 20 watt bulb for underneath and inside of your microwave. I hope this helps. Good luck.

Hi Barbara, thank you for reaching out. According to our research, we would suggest checking the lamp socket first. If it is fine, the issue could be with the halogen bulb, part number PS2339783. You may need to replace it to fix the issue. We hope this solves your problem!

Hello Dana, thank you for your question. We have researched the model you have provided, and the part number PS2339783 is the correct part for your appliance. We hope this helps!

Hello John, thank you for your inquiry. Use the following instructions to install a light bulb: 1. First, disconnect the power at the main fuse or circuit breaker panel, or unplug the oven. 2. Remove the screw from the side of the light compartment cover and lower the cover until it stops. 3. Be sure the bulb to be replaced is cool before removing it. Gently pull the bulb from the receptacle. 4. Replace the light bulb. Firmly push the light bulb into the holes so that it is properly installed. A burned-out bulb could be caused by a loose connection. Therefore, push the bulb into the socket. We hope this information is useful!