Basket Drive Assembly with Clutch W10820043

After each spin down, there is a loud clunk/bang. The washer makes it through all cycles fine (i did notice that clothes are a little wet near bottom). Could this be the clutch? The spindle/clutch? Both? ... (i thought about pump, but it does work). there is no other noise, so i didn't think it bearing or coupling. ideas?

Having issue w if load a little heavy basket doesnt spin out if i hand turn basket sometimes i can get it spin out. .What part do i need

Machine makes a whining noise in spin cycle and during this makes a cracking noise. If you manually run the machine and hold the agitator all noise stops.

We have replaced the clutch and transmission at the suggestion by a repair tech. Unit will agitate, drain and will spin without cloths/load. But if we run a normal load the cloths come out very wet, unit will not spin with a load?

Hi my wash machine makes a loud rattling sound when the spin cycle starts. It isn't a steady rattle, it has a rhythm, like rattle, rattle, rattle, etc. As the drum picks up speed, so does the rattle. When it nears full speed, the rattling sound gets less loud and then goes away. I also notice that when the machine is done, sometimes the basket spins freely, other times it doesn't spin. It normally would not spin when it is off. The machine seems to be washing the clothes properly, other then on very few occasions the clothes felt a little more damp then usual. Thanks, ron

I have a Maytag centennial, m# mvwc6esww1 and s# cy2942533. Our washer runs through its normal cycle, but at the end when spinning not all of the water is out of the clothes. Its almost like the rpm of the washer isnt spinning fast enough to "throw" the water off the clothes. Any suggestions on parts that would fix this? I have checked the pump and there are no obstructions and the drain line is free as well of any debris. Thanks in advance.

My Whirlpool washer will agitate but the basket won't spin. The motor couplers are in tact, do you think this would be a clutch problem? Thank you

Hello, my washer just started making a medium loud higher pitched whine noise only when the water is dumping. Still drains successfully however. I suspect it might be the drain pump, and it is the original pump from 1993. Would this be correct, and are there any other parts i should change at same time? Only agitator cogs and fill/drain valve have ever been replaced. Thanks.

Hi, i have a Estate made by Whirlpool top load washer it stopped agitating so i put a brand new clutch today and it still is the same the little top part turns but the bottom doesn't turn can you help me.

This stacked washer/dryer makes a loud grinding sound on the spin cycle only. I also am finding a black powder substance on the floor under the back of the washer when i move it out.What part do i need and how do i access it to replace it ?