SELECTOR BOARD WB27X10860

Hello JIm and thanks for writing. If the control is defective it may not shut off a relay when the function is complete, and then opening the door to interrupt the power to the control would be the only way to terminate the cycle. If you have this symptom, the control board may be at fault. Unplug the unit and remove the cabinet. If the relays are not part of the control board, you should check the output terminals on them for continuity first. There shouldn’t be continuity when the relay is not powered. If the relays check okay, then the control board is likely defective. use a Phillips head screwdriver to unthread the two mounting screws securing the grill with the screws unthreaded open the oven door then slide the grill to the left and lift it up to remove next remove the control panel mounting screw lift the control panel up to detach note the orientation of the wires connect it to the control board then depress the locking tabs if necessary to disconnect the wires remove the screws securing the grounding wire and set the control panel on a sturdy surface release the ribbon connector now and thread the mounting screws securing the main control board to the housing with the screws removed lift out the board prepare the new control panel for installation by removing all of the protective coverings make sure the new switch cable is inserted through the hole in the control board housing then position the board in the housing thread the screws to secure the ribbon connector secured the grounding wire to the control board housing reconnect the remaining wires to the appropriate terminals on the board now insert the control panel tabs into the slots in the frame and push the panel down replace the mounting screw to secure insert the tabs on the grille into the slots in the frame and slide the grille to the right rethread the mounting screws with the repair completed plug the power cord back in and your microwave oven should be ready for use We hope this helps. Please contact us anytime.

Hi Jim, thank you for contacting us. Unfortunately we do not have installation information specific for your model. The installation though is very much the same as what we listed in the previous answer. Instead of a grille, you would just have to remove your control panel instead of a grille. To remove the control panel, all you would have to do is open up your door. Across the bottom of the panel there should be screws that you need to remove. Then close your door. Lift the control panel up and that is how you remove it. Be careful not to pull away before you unplug the electrical parts. Good luck with your repair.

Hi Kristin, Thank you for your question. If you are selecting a cycle and the washer is not recognizing it, then the selector board may be malfunctioning and it will need to be replaced. The part number listed under your model number for the selector board is PS1021783. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.