ZSEB420DYB General Electric Refrigerator - Instructions

Followed instruction video to replace flapper,dispenser door recess crank and torsion spring. Turns out all these parts were good, however the solenoid valve was crusted with rust. Remved valve and cleaned plunger with knife,sandpaper and wd40. Wala everything is back to normal.

Your Video really made it easy, showing the actual replacment of the part. However I did have one problem, which was I could not unplug the panel just by pulling on the plugs. A locking catch is on each plug so I just moved the panel out of the way.

Follow instruction on the video you provided

Easy, with included video and instructions

1. Removed and tested defrost heater, tests good. 2. Reinstalled defrost heater. 3. Removed and tested defrost over-temperature sensor, tests good. 4. Reinstalled over-temperature sensor using soldering iron, dielectric silicone grease, and heat-shrink tubing. 5. Removed the control printed circuit board and checked for blown fuse's, fuse's are all good. 6. Removed the defrost relay from the printed circuit board using soldering iron, bench tested the relay, it is good. 7. Soldered defrost relay back onto the circuit board, and reinstalled control board. 8. Removed and bench tested evaporator thermistor, the resistance is out of specification, ordered new thermister. 9. Installed new thermistor using soldering iron, dielectric silicone grease, and heat-shrink tubing. 10. Re-assembled refrigerator. 11. Installed temperature monitoring and recording instrumentation for 72 hour test. The defrost cycle is running correctly with a defrost termination temperature of around 90 deg-f. The defrost cycle ran twice while running the 72 hour test. 11. Removed test instrumentation and Put the unit back into service, The thermistor was the culprit. I bought the right part on the first shot, nice.

Removed front Trim panel of despenser. Took pictures every step just incase! Remove control panel, push up and out! Remove 4 Phillip screws. Pull out Ice funnel, replaced torsion spring installed new one on ice funnel. Installed new micro switch by ice funnel. Recess crank removed from door were ice comes out. Installed new one . Cleaned all parts inside. Installed everything back! Easy took about a half hour,taking my time! Saved me about $300 . Thanks PartSelect.com!