Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Ice Maker Auger Wouldn't Turn
I removed the ice tray and removed the front plastic cover that simply snapped off. I removed 4 hex screws with 1/4" nut driver. Then pulled the auger forward. This allowed me to slide the end cap into place. I put the auger in place and retightened the 4 hex screws, snapped on the plastic cover it worked fine
The large "pan" (I'd call it a drawer) broke on my Amana refrigerator...apparantly a common problem with this refrige.
After going to the Amana website and not finding my refrigerator even listed there (it is less than 6 years old) I emailed them, but decided to do my own search and found this website. Ordering the part was easy and was delivered within the week.
end cap broke under tlhe weight of ice and other frozen items that were ill placed
removed the ice maker tray and screws and that held the cover to the rotating mechanism that crushes and dispenses the ice. the end cap is then attached to the rotating mechanism and ice container, the cover is replaced;finishing the job.
The right door was sagging and the handles were rubbing together
First, remove the plastic cover off the top hinge by removing the single phillips head screw.
Removed the three hex-head screws holding the hinge to the body of the fridge and then lift the hinge off of the door.
Lift the door off the bottom hinge and place on a flat surface so you can easily access the bottom.
Remove the single hex-head screw from the center of the door part of the closure cam and pull it free. Install the new part.
Next, remove the bottom portion of the closure cam from the lower door hinge (still attached to the fridge) by removing the single hex-head screw. Install the new part.
If needed, lube the lower door hinge with Vaseline and carefully set the door back on. (This is the hard part if you are working alone, as it can be hard to line up the hole.)
Lube the top hinge, reinstall, and replace the plastic cover. Easy as 1, 2, 3.
bins would not stay on track due to broken back tabs
I removed the old bins, making sure to get all the pieces that had broken from the back tabs where they slide into the upper support racks. The replacement bins slid in easily and work perfectly.
the dairy door cracked within a week of the purchase
Within a 2 months of purchase the compressor on This refrigerator this unit failed. and again two years later. After all of that, we were pleased to find a replacement dairy door for this unit. thank you!
Plastic Cams on frig door cracked in halk/door wouldn't close easily
Removed the top hinge (4 screws)-lifted the door off of the lower hinge-replaced both halves of the cam kit and mounted the door and reattached the upper hinge. Probably took about fifteen minutes total.
The worst part was unloading the door shelves. Removed upper hinge cover and hinge hex screws. This allows the door to be removed. Lay the door on side. Remove screw that holds cam in place. Replace broken cam with new piece. Put the door back on the hinge pin and replace upper hinge screws and cover. Now reload all of the stuff.
The ice storage bin broke and the ice driver sleeve broke. Needed replacement to make the ice dispenser work.
removed ice bin from the fridge. snaped off the front plate. Removed 4 screws. this led to freeing up the auger. removed it and put the auger into the new bin and replace the front parts. Put storage bin back into fridge. Done. Might want to keep some ice cubes in a separte container until done. Not hard.