WWA7650SALWW General Electric Washer - Instructions

Tried using 5 minute epoxy to glue gear portion back to knob portion first. That didn't work so I ordered a new one. Piece of cake to install!! Not even 1 minute....

I opened the box which contained the new selector knob. Placed it on my dryer and immediately turned the knob to start the dryer. Easy steps to follow the video supplied when i ordered the part. I am greatful you responded to my order within 3 days. Thanks

pulled the clip 1/2 way out inserted knob and it snapped into place.

Pushed new knob on starter shaft.

Just took the old knob off and put the new knob on. It was a snap. Thanks you very much

put the new knob on and pushed it inward !! simple repair..PartSelect is a great company to do business with and very quick shipping, and great prices too. thank you so much.Brad S.

first I'm 77 years old/and prod of myself. I follow google instruction.and did it. washer work like a charm. and it oondly cost me $12.92 with shiping. thanks.

Simple replacement. Very easy.

I used a pair of pliers to turn my dryer on until I broke the center part where the knob went. I order the part that was in the dryer first and it came the next day. When it got here I realized I still needed the knob. It came the next day also. It took my handyman about 15 minutes to replace both and he also cleaned out all of the missing socks and other items behind my dryer. Good Job!

Ordered new knob,came two days later.Really inpressed with their Service.Installed new knob within seconds.Took longer to open the plastic it was in.If you need parts,I would suggest ordering them thru PartSelect.com.

Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside edge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.

Unscrew the back cover to washer, Find 3 hole plug, plug in the cord, take the ground wire and screw it to the screw next to the cord that is screwed into the metal frame, put the back panel on and that's it! easy peasy! Remember to hook up your water hoses and turn on the water to check for leaks BEFORE plugging it in! Very Easy!